《AS NZS 60598.2.1-1998 Title Luminaires Part 2.1 Particular requirements— Fixed general purpose luminaires.pdf》由会员分享，可在线阅读，更多相关《AS NZS 60598.2.1-1998 Title Luminaires Part 2.1 Particular requirements— Fixed general purpose luminaires.pdf（10页珍藏版）》请在三一文库上搜索。
1、AS/NZS 60598.2.1:1998 IEC 598-2-1:1979 IEC 598-2-1:1979/Amdt 1:1987 Australian/New Zealand Standard Title: Luminaires Part 2.1: Particular requirements Fixed general purpose luminaires IEC title: Luminaires, Part 2: Particular requirements Section 1: Fixed general purpose luminaires AS/NZS 60598.2.1
2、:1998 This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee EL/41, Lamps and Related Equipment. It was approved on behalf of the Council of Standards Australia on 3 December 1997 and on behalf of the Council ofStandardsNewZealandon28 November1997.Itwaspublishedon 5 Mar
3、ch 1998. The following interests are represented on Committee EL/41: Association of Consulting Engineers, Australia Australian Electrical and Electronic Manufacturers Association Electrical Compliance Testing Association of Australia Energy Efficiency and Conservation Authority of New Zealand Illumi
4、nating Engineering Society of Australia and New Zealand Ministry of Commerce, New Zealand Regulatory authorities (electrical) Telarc, New Zealand Review of Standards. To keep abreast of progress in industry, Joint Australian/ New Zealand Standards are subject to periodic review and are kept up to da
5、te by the issue of amendments or new editions as necessary. It is important therefore that Standards users ensure that they are in possession of the latest edition, and any amendments thereto. Full details of all Joint Standards and related publications will be found in the Standards Australia and S
6、tandards New Zealand Catalogue of Publications; this information is supplemented each month by the magazines The Australian Standard and Standards New Zealand, which subscribing members receive, and which give details of new publications, new editions and amendments, and of withdrawn Standards. Sugg
7、estions for improvements to Joint Standards, addressed to the head office of either Standards Australia or Standards New Zealand, are welcomed. Notifi cation of any inaccuracy or ambiguity found in a Joint Australian/New Zealand Standard should be made without delay in order that the matter may be i
8、nvestigated and appropriate action taken. This Standard was issued in draft form for comment as DR 97106. AS/NZS 60598.2.1:1998 Australian/New Zealand Standard Luminaires Part 2.1: Particular requirements Fixed general purpose luminaires First published as AS/NZS 60598.2.1:1998. PUBLISHED JOINTLY BY
9、: STANDARDS AUSTRALIA 1 The Crescent, Homebush NSW 2140 Australia STANDARDS NEW ZEALAND Level 10, Radio New Zealand House, 155 The Terrace, Wellington 6001 New Zealand ISBN 0 7337 1742 X ii PREFACE ThisStandardwaspreparedbytheJointStandardsAustralia/StandardsNewZealand Committee EL/41, Lamps and Rel
10、ated Equipment, to supersede AS 31371992, Approval and test specificationLuminaires (lighting fittings), on 1 January 2005. Until that date both Standards will remain current. The objective of this Standard is to specify minimum safety requirements for fixed general purpose luminaires for use with t
11、ungsten filament, tubular fluorescent and other discharge lamps with a supply voltage not exceeding 1000 V. ThisStandardisidenticalto*,andreproducedfrom,IEC 598-2-1:1979,Luminaires, Part 2: Particularrequirements,Section 1Fixedgeneralpurposeluminaires,andincludes Amendment 1:1987. The clauses change
12、d by the Amendment are indicated by a single marginal bar, with a 1 beside it, set adjacent to the amended text. IEC has decided to apply a new numbering system, the 60000 series, to all its existing and future publications, including amendments to existing Standards. As a consequence, IEC has modif
13、ied the bibliographic references in its databases to accord with the new numbering system. All IEC publications issued since the beginning of 1997 will carry references in terms of the 60000 series numbering. Publications printed earlier than 1997 will continue to carry the old series of numbers. Fo
14、r example, a reference to IEC 60598 series of Standards will be to IEC 598 if the current edition of the Standard was printed prior to 1997. As this Standard is reproduced from an international Standard, the following applies: (a)Its number does not appear on each page of text and its identity is sh
15、own only on the cover and title page. (b)In the source text this International Standard should read this Australian/New Zealand Standard. (c)A full point substitutes for a comma when referring to a decimal marker. (d)Reference to the international Standard should be replaced by reference to the foll
16、owing Australian/New Zealand Standards: Reference to International StandardAustralian/New Zealand Standard IECAS/NZS 598Luminaires60598Luminaires 598-1Part 1: General requirements and tests60598.1Part 1: General requirements and tests * WhilethisdocumentisidenticaltoIEC 598-2-1:1979thereareAustralia
17、nandNewZealandvariationsin AS/NZS 60598.1:1998 to which this Standard refers for the majority of its requirements. Thus an item complying with IEC 598-2-1:1979 (including Amendment 1:1987) may not comply with AS/NZS 60598.2.1:1998. iii CONTENTS Page Clause 1.1Scope . . . . . . . . . . . . . . . . .
18、. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.2General test requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.3Definitions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
19、. . . . . . . . . . . . . . . 1 1.4Classification of luminaires. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.5Marking. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.6Construction. . . .
20、. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.7Creepage distance and clearance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.8Provision for earthing. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
21、 . . . . . . . . . . . . . . . . . . 2 1.9Terminals. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.10External and internal wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.11Protection
22、against electric shock. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.12Endurance tests and thermal tests. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.13Resistance to dust and moisture. . . . . . . . . . . . . . . . . . . . . .
23、. . . . . . . . . . . . . . . . . . 2 1.14Insulation resistance and electric strength. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.15Resistance to heat, fire and tracking. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Amendment 1:1987 . . . . . . .
24、 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CopyrightSTANDARDS AUSTRALIA/STANDARDS NEW ZEALAND Users of Standards are reminded that copyright subsists in all Standards Australia and Standards New Zealand publications and software. Exceptwhere the
25、Copyright Actallows and except where providedfor below no publicationsor software produced by Standards Australia or Standards New Zealand may be reproduced, stored in a retrieval system in any form or transmitted by any means without prior permission in writing from Standards Australia or Standards
26、 New Zealand. Permission may be conditional on an appropriate royalty payment. Australian requests for permission and information on commercial software royalties should be directed to the head office of Standards Australia. New Zealand requests should be directed to Standards New Zealand. Up to 10
27、percent of the technical content pages of a Standard may be copied for use exclusively in-house by purchasers of the Standard without payment of a royalty or advice to Standards Australia or Standards New Zealand. Inclusion of copyright material in computer software programs is also permitted withou
28、t royalty payment provided such programs are used exclusively in-house by the creators of the programs. Care should be taken to ensure that material used is from the current edition of the Standard and that it is updated whenever the Standard is amended or revised. The number and date of the Standar
29、d should therefore be clearly identified. The use of material in print form or in computer software programs to be used commercially, with or without payment, or in commercial contracts is subject to the payment of a royalty. This policy may be varied by Standards Australia or Standards New Zealand
30、at any time. iv NOTES 1 1 AUSTRALIAN/NEW ZEALAND STANDARD Luminaires Part 2.1: Particular requirementsFixed general purpose luminaires 1.1Scope This section of Part 2 of IEC Publication 598 specifies requirements for fixed general purpose luminaires for use with tungsten filament, tubular fluorescen
31、t and other discharge lamps on supply voltages not exceeding 1 000 V. It is to be read in conjunction with those sections of Part 1 to which reference is made. 1.2General test requirements The provisions of Section Zero of Publication 598-1 apply. The tests described in each appropriate section of P
32、art 1 shall be carried out in the order listed in this section of Part 2. 1.3Definitions For the purposes of this section, the definitions of Section One of Publication 598-1 apply. 1.4Classification of luminaires Luminaires shall be classified in accordance with the provisions of Section Two of Pub
33、lication 598-1. 1.5Marking The provisions of Section Three of Publication 598-1 apply. 1.6Construction The provisions of Section Four of Publication 598-1 apply. 1.7Creepage distances and clearances The provisions of Section Eleven of Publication 598-1 apply. COPYRIGHT 2 2 1.8Provision for earthing
34、The provisions of Section Seven of Publication 598-1 apply. 1.9Terminals The provisions of Sections Fourteen and Fifteen of Publication 598-1 apply. 1.10External and internal wiring The provisions of Section Five of Publication 598-1 apply. 1.11Protection against electric shock The provisions of Sec
35、tion Eight of Publication 598-1 apply. 1.12Endurance tests and thermal tests 1 The provisions of Section Twelve of Publication 598-1 apply. 1.13Resistance to dust and moisture 1 The provisions of Section Nine of Publication 598-1 apply. 1.14Insulation resistance and electric strength The provisions
36、of Section Ten of Publication 598-1 apply. 1.15Resistance to heat, fire and tracking The provisions of Section Thirteen of Publication 598-1 apply. COPYRIGHT 3 3 Amendment 1.12Endurance tests and thermal tests At the end of the first paragraph, add the following: Luminaires with an IP classification
37、 greater than IP20 shall be subjected to the relevanttestsofClauses 12.4,12.5and12.6ofSectionTwelveof Publication 598-1 after the test(s) of Clause 9.2 but before the test(s) of Clause 9.3 of Section Nine of Publication 598-1 specified in Clause 1.13 of this Section of Publication 598-2. 1.13Resista
38、nce to dust and moisture At the end of the first paragraph, add the following: For luminaires with an IP classification greater than IP20 the order of the tests specified in Section Nine of Publication 598-1 shall be as specified in Clause 1.12 of this Section of Publication 598-2. COPYRIGHT This page has been left blank intentionally.