《ECA-EIA-364-16A-2002.pdf》由会员分享,可在线阅读,更多相关《ECA-EIA-364-16A-2002.pdf(14页珍藏版)》请在三一文库上搜索。
1、 EIA STANDARD TP-16A Stripping Force Test (Solderless Wrapped Connectors) Test Procedure for Electrical Connectors EIA-364-16A (Revision of EIA-364-16) APRIL 2002 ELECTRONIC COMPONENTS, ASSEMBLIES see figure 1. 4 Test procedure 4.1 The test fork shall be moved parallel to the post axis, toward the f
2、ree end of the post at a rate of 25.4 millimeters to 50.8 millimeters (1 inch to 2 inches) per minute. 4.2 The force exerted on the wrapped connection by the test fork as it moves shall be measured. 4.3 The maximum force which is required to move the whole wrapped connection along the post a distanc
3、e equivalent to one wire diameter shall be measured as the stripping force. 5 Details to be specified The following details shall be specified in the referencing document: 5.1 Number of specimens to be tested 5.2 Selection method for specimens 5.3 Special conditions or requirements differing from th
4、ose above 6 Test documentation Documentation shall contain the details specified in clause 5, with any exceptions, and the following: 6.1 Title of test 6.2 Specimen description including wire size and number of wraps 6.3 Test equipment used, and date of last and next calibration 6.4 Test and procedu
5、re 6.5 Values and observations 6.5.1 Rate of movement of test fork 6.5.2 Measured value of stripping force 6.5 3 Other data required by the referencing document 6.6 Name of operator and date of test Copyright Electronic Components, Assemblies & Materials Association Provided by IHS under license wit
6、h ECA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 02:56:00 MDTNo reproduction or networking permitted without license from IHS -,-,- EIA-364-16A Page 3 Figure 1 Stripping force test fixture Strip force Post Fixed mount Fork tines Solderless wrapped connection Free
7、 end of post Stripping tool Fork Copyright Electronic Components, Assemblies & Materials Association Provided by IHS under license with ECA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 02:56:00 MDTNo reproduction or networking permitted without license from IHS -,-
8、,- Copyright Electronic Components, Assemblies & Materials Association Provided by IHS under license with ECA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 02:56:00 MDTNo reproduction or networking permitted without license from IHS -,-,- EIA Document Improvement Pr
9、oposal If in the review or use of this document, a potential change is made evident for safety, health or technical reasons, please fill in the appropriate information below and mail or FAX to: Electronic Industries Alliance Technology Strategy & Standards Department Publications Office 2500 Wilson
10、Blvd. Arlington, VA 22201 FAX: (703) 907-7501 Document No. Document Title: Submitters Name: Telephone No.: FAX No.: e-mail: Address: Urgency of Change: Immediate: At next revision: Problem Area: a. Clause Number and/or Drawing: b. Recommended Changes: c. Reason/Rationale for Recommendation: Addition
11、al Remarks: Signature: Date: FOR EIA USE ONLY Responsible Committee: Chairman: Date comments forwarded to Committee Chairman: Copyright Electronic Components, Assemblies & Materials Association Provided by IHS under license with ECA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale
12、, 03/30/2007 02:56:00 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright Electronic Components, Assemblies & Materials Association Provided by IHS under license with ECA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 02:56:00 MDTNo re
13、production or networking permitted without license from IHS -,-,- Copyright Electronic Components, Assemblies & Materials Association Provided by IHS under license with ECA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 02:56:00 MDTNo reproduction or networking permi
14、tted without license from IHS -,-,- Copyright Electronic Components, Assemblies & Materials Association Provided by IHS under license with ECA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 02:56:00 MDTNo reproduction or networking permitted without license from IHS -,-,-