《笔记本安规测试.ppt》由会员分享，可在线阅读，更多相关《笔记本安规测试.ppt（19页珍藏版）》请在三一文库上搜索。
1、,Safety Test,Test Item,Insulation Resistance Test Insulation Endurance Test Leakage Current Test Inrush Current Test,Insulation Resistance Test,Aim Verify insulation strength of products (驗證產品的絕緣強度) Spec Test point: (A+B)FG Test voltage: DC500V Test time:1minute System condition: System power off Cr
2、iteria Insulation Resistance: 10meg ohm,Step,Insulation Endurance Test,Aim Insulation Strength is tested using far higher than normal voltage to observe whether insulation is damaged or leakage current is too high.(以高於正常使用電壓的條件測試產品之絕緣強度,以觀察絕緣是否崩潰或洩漏電流是否過高,判定產品是否安全),Spec Test point : (A+B) FG Test vo
3、ltage: AC 1.5KV(130250) AC 1.0KV(Less than130V) Test time: 1 minute System condition: System power off Criteria Leakage Current: 10mA,Step,Leakage Current,Aim Under normal voltage,simulating when body contacts product,the current is checked whether to damage the safety of body. (在正常的工作電壓下，模擬人體接觸產品時流
4、經人體之電流量以檢視該電流量是否危害人身安全。) Spec *Test point: A FG, B FG, FGEarth,Palm RestEarth,*Input Resistance: 1.5Kohm *Input capacity: 0.15F *Input voltage: Standard voltage +10% Criteria:,Step,AC 220V,N/B之电源插座,AC Power Source,Inrush Current,Aim 驗證產品在開關暫態之電流突破是否合乎產品規格 Spec Test voltage: 100V / 230V Test frequency: 50HZ / 60HZ Trigger point: AC plug in Measure times: 5 times for each Condition: System cold,Measure Item: Inrush current: 0 to peak Lasting time: The time from the start to x1.25 with standard current value 其中x的确定为:从波形start到波形稳定时的緃坐标 之差 Criteria: Inrush Current: 52A Lasting Time: 500ms,