《测回法四中英文翻译大全.doc》由会员分享,可在线阅读,更多相关《测回法四中英文翻译大全.doc(7页珍藏版)》请在三一文库上搜索。
1、先将 经纬仪 安置 好,进行 对 中,整 平,并 在A,B两点 树立 标杆 或 测 钎 作为 照准 标志,然后 即可 进行 测 角 一 测 回 的 操作程序 如下. :( 1)盘 左 位置,照准 左边 目标A,对 水平 度 盘 置 数,略大于0 ,将 读数to左 记 入手 簿;( 2)顺时针 方向 旋转 照准 部,照准 右边 目标B,读取 水平 度 盘 读数b左,记 入手 簿.由此 算得 上 半 测 回 的 角 值:左=b左- to左( 3)盘 右 位置,先 照准 右边 目标B,读取 水平 度 盘 读数b右,记 入手 簿;( 4)逆时针方向 转动 照准 部,照准 左边 目标A,读取 水平 度
2、盘 读数to右,记 入手 簿.由此 算得 下 半 测 回 的 角 值:右=b右- to右.对于DJ6经纬仪,上,下 两个 半 测 回 所 测 的 水平角 之 差 不应 超过 36 .如 需要 观测 多个 测 回,则 各 测 回 起始 方向 的 置 数 应按180/ n递增.但 应 注意,不论 观测 多少 个 测 回,第一 测 回 的 置 数 均 应当 为0 .各 测 回 观测 角 值 互 差 不应 超过 24 .Theodolite placed first good conduct alignment, leveling andA,BEstablish a benchmark measure
3、 two or brazing as sighting marks,You can then carry out a test back angle measurement procedure is as follows :( 1 )Face position , sighting the left goalA, Set the number on the horizontal circle , slightly larger than the0, the readingtoLeft creditedHand-book ;( 2 )Alidade clockwise , the right o
4、f the target sightingBRead horizontal circle readingbLeft , remember to start book.Thus be regarded as the first half of the measured angle value back :Left =bLeft- ToLeft( 3 )Plate right position , the right of first sighting targetBRead horizontal circle readingbRight, remember to start book ;( 4
5、)Counterclockwise rotating alidade , sighting the left goalARead horizontal circle readingtoRight, remember to start book.Thus be regarded as the second half of the measured angle value back :Right =bRight- ToRight .ForDJ6Theodolite, on the next two and a half rounds of the measured horizontal angle
6、 difference shall not exceed 36. If you need more than one observation rounds , then back to the initial direction of the measuring device shall be the number of180/ NIncrements. Note, however, notOn observing the number of rounds, the number of the first set of measurements shall return to0. Various rounds observations angular difference between each value should not exceed 24