《SAE AS 7928-4-1999 Terminals, Lug and Splices, Conductor, Crimp Style,Copper Terminal, Lug, Insulated, Ring Tongue, Bell-Mouthed,Type II, Class 1.pdf》由会员分享,可在线阅读,更多相关《SAE AS 7928-4-1999 Terminals, Lug and Splices, Conductor, Crimp Style,Copper Terminal, Lug, Insulated, Ring Tongue, Bell-Mouthed,Type II, Class 1.pdf(6页珍藏版)》请在三一文库上搜索。
1、 AEROSPACE STANDARD AMENDMENT Terminals, Lug and Splices, Conductor, Crimp Style, Copper Terminal, Lug, Insulated, Ring Tongue, Bell-Mouthed, Type II, Class 1 (for 150C Total Conductor Temperature) SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the stat
2、e of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five yea
3、rs at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2004 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic,
4、mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: custsvcsae.org SAE WEB ADDRESS: http:/www.sae.org Issued 2004-09 x AS7928/4-A1
5、 Present Requirement: Note 10 on sheet 8 THE COLOR RING MUST COVER A MINIMUM OF 315 OF THE CIRCUMFERENCE, IN LIEU OF THE WIRE SIZE COLOR RING, 3 OR MORE LONGITUDINAL STRIPES EQUALLY SPACED ON THE INSULATION PORTION OF THE TERMINAL MAY BE USED. THE STRIPES MUST EXTEND TO WITHIN 1/16” OF THE ENDS OF T
6、HE INSULATION AND MUST NOT OBLITERATE THE BASIC SLEEVE COLOR. TERMINAL LUGS MANUFACTURED PRIOR TO 8 JUNE 1981, AND MARKED WITH 2 LONGITUDINAL STRIPES MAY BE USED UNTIL THE SUPPLY IS EXHAUSTED. Change Requirement: Note 10 on sheet 8 THE COLOR RING MUST COVER A MINIMUM OF 315 OF THE CIRCUMFERENCE. IN
7、LIEU OF THE WIRE SIZE COLOR RING, 2 OR MORE LONGITUDINAL STRIPES EQUALLY SPACED ON THE INSULATION PORTION OF THE TERMINAL MAY BE USED. THE STRIPES MUST EXTEND TO WITHIN 1/16” OF THE ENDS OF THE INSULATION AND MUST NOT OBLITERATE THE BASIC SLEEVE COLOR. Rationale for Change: Navy EPL letter 10380, 444-JRM/M10.13 of OCT 30 1990 - - - - - - - - - - - - - - - - - - - - - - - - - - R s R rq R R rq rq s R q