《ANSI-K62.283-1988-R1997.pdf》由会员分享，可在线阅读，更多相关《ANSI-K62.283-1988-R1997.pdf（2页珍藏版）》请在三一文库上搜索。
1、A N S I K62*283 88 B M 0724150 0007527 2 o - ANSI K62.283-1988 American National Standard common name for the pest control chemical - 2,4-dimet h yl-N-phenyl- 5- t hiazolecar boxamide “met s u If o va x“ Approved March 23,1988 Secretariat: U.S. Department of Agriculture 1. Common Name : metsulfovax
2、1.1 The word “metsulfovax” (pronounced mat-sul-f- vax) has been accepted as the American National Stan- dard Common Name for the chemical 2,4-dimethyl-N- phenyl-5-thiazolecarboxamide. 1.2 Acceptance signifies compliance with American National Standard Common Name for a Pest Control Chemical -Procedu
3、re for Acceptance, ANSI K62.1- 1985. 2. Use of Common Name 2.1 The common name applies to the 100% pure chemical. 2.2 Technical grades and formulations shall indicate the percentage of metsulfovax present; for example, metsulfovax - approximately 92-95%. 2.3 The sponsor2 of the common name “metsulfo
4、fax” has agreed to release and permit the use of the name Also known as 2,4-dimethyl-5-thiazolecarboxanilide. Name furnished upon request. Page 1 of 2 pages “metsulfovax” with respect to any product, whether or not manufactured or formulated by it, which con- tains a pest control chemical conforming
5、 to the de- scription set forth in this American National Standard. 3. Limitations Neither the American National Standards Institute nor the Accredited Standards Committee for Common Names for Pest Control Chemicals, K62, guarantees or assumes any responsibility that use of this name in con- nection
6、 with this or any other chemical or product will not infringe on or conflict with any existing propri- etary name, trademark, or trade name. Approval as an American National Standard Common Name consti- tutes recognition by the Institute that a consensus ex- ists within Accredited Standards Committe
7、e K62, oper- ating under Institute procedures and basing its recom- mendation on data submitted by a sponsor, favoring consideration of the use of the name to designate the pest control chemical described herein by all interested persons. The information concerning the chemical and physical properti
8、es of the chemical is not a part of the standard but is provided solely as an aid to identifica- tion, and its accuracy is not guaranteed. An American National Standard implies a consensus of those substantially concerned with its scope and provisions, An American National Standard is intended as a
9、guide to aid the manufacturer, the consumer, and the general public. The existence of an American National Stan- dard does not in any respect preclude anyone, whether he has approved the standard or not, from manufacturing, marketing, purchasing, or using products, processes, or procedures not confo
10、rming to the standard. American National Standards are subject to periodic review and users are cautioned to obtain the latest editions. The American National Standards Institute does not develop standards and will in no circumstances give an interpretation of any American National Standard. Moreove
11、r, no person sha have the right or authority to issue an interpretation of an American National Standard in the name of the American National Standards Institute. CAUTION NOTICE: This American National Standard may be revised or withdrawn at any time. The procedures of the American National Standard
12、s Institute require that action be taken to reaffirm, revise, or withdraw this standard no later than five years from the date of ap- proval. Purchasers of American National Standards may receive current information on all standards by calling or writing the American Na- tional Standards Institute.
13、Copyright O 1988 by American National Standards Institute, 1430 Broadway, New York, N.Y. 10018 ANSI5C588/5 A : K- -. f Copyright American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=OConnor, Maurice Not for Resale, 04/29/2007 11:41:49
14、MDTNo reproduction or networking permitted without license from IHS -,-,- ANSI Kb2-283 88 0724350 0007530 7 Page 2 of 2 pages (This Appendix is not part of American National Standard K62.283-1988, but is included for informa- Appendix tion . only.) me tsulfovax Physical and Chemical Properties Syste
15、matic name 2 ,4-dimethyliN-phenyl-5 -thiazolecarboxamide CAS Registry Number 2 1452-18-6 Empirical formula ClHlzNzOS Molecular weight 232.30 Structural formula Color Melting range Solubility white crystalline solid 140-1 42C g solute/100 g solvent at 25C acetone 22.9 toluene 1.7 dimethyl sulfoxide 4
16、0.9 water 2.5 X Proposed Uses Metsulfovax is intended for use as a seed treatment or foliar-applied fungicide. Foliar rates of 1.0-2.0 lbs/acre (1.12-2.24 kg/ha) and seed treatment rates from 1 .O-8.0 oz/IOO lbs seed (0.62-5.00 g/kg seed) control various smut, bunt, and rust diseases. This material
17、is reproduced from American National Standard KL2.283 , copyright 14gX , with permission ofthe American National Standards Institute, Inc. Not for resale. No part of this publication may be copied or reproduced in any form, electronic retrieval system or otherwise, without the prior written permissi
18、on of the American National Standards Institute, Inc., 11 West 42nd Street, New York, New York 10036. ANSI K62.283-1988 Copyright American National Standards Institute Provided by IHS under license with ANSI Licensee=IHS Employees/1111111001, User=OConnor, Maurice Not for Resale, 04/29/2007 11:41:49 MDTNo reproduction or networking permitted without license from IHS -,-,-