《BS-EN-12503-1-2001.pdf》由会员分享，可在线阅读，更多相关《BS-EN-12503-1-2001.pdf（10页珍藏版）》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 12503-1:2001 Incorporating Corrigendum No. 1 Sports mats Part 1: Gymnastic mats, safety requirements The European Standard EN 12503-1:2001 has the status of a British Standard ICS 97.220.30 ? BS EN 12503-1:2001 This British Standard, having been prepared under the direction of
2、 the Consumer Products and Services Sector Committee, was published under the authority of the Standards Committee and comes into effect on 15 June 2001 BSI 16 December 2002 ISBN 0 580 37267 7 National foreword This British Standard is the official English language version of EN 12503-1:2001, includ
3、ing Corrigendum July 20002. Together with BS EN 12503-2:2001, BS EN 12503-3:2001, BS EN 12503-4:2001, BS EN 12503-5:2001, BS EN 12503-6:2001 and BS EN 12503-7:2001, it supersedes BS 1892-2.10:1990 which will be withdrawn on 15 August 2001. The UK participation in its preparation was entrusted to Tec
4、hnical Committee SW/14, Gymnasium and sports equipment, which has the responsibility to: A list of organizations represented on this committee can be obtained on request to its secretary. Additional information Mat types 1 and 2 Mat types 1 and 2 are intended primarily for use in school gymnastics a
5、t the discretion of qualified teachers for the purpose of agility exercises. Guidance on mats and their use may be obtained from the relevant Local Authority or the British Association of Advisers and Lecturers in Physical Education (BAALPE), www.baalpe.org. Flame retardancy For sports matting used
6、in the UK certain minimum levels of flame retardancy and the required test methodology will be detailed in BS 1892-3, which is in preparation. Cross-references The British Standards which implement international or European publications referred to in this document may be found in the BSI Catalogue
7、under the section entitled “International Standards Correspondence Index”, or by using the “Search” facility of the BSI Electronic Catalogue or of British Standards Online. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct
8、application. Compliance with a British Standard does not of itself confer immunity from legal obligations. aid enquirers to understand the text; present to the responsible European committee any enquiries on the interpretation, or proposals for change, and keep the UK interests informed; monitor rel
9、ated international and European developments and promulgate them in the UK. Summary of pages This document comprises a front cover, an inside front cover, the EN title page, pages 2 to 6, an inside back cover and a back cover. The BSI copyright date displayed in this document indicates when the docu
10、ment was last issued. Amendments issued since publication Amd. No. DateComments 14130 Corrigendum No. 1 16 December 2002 Changes to Table 3 EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 12503-1 April 2001 ICS 97.220.30 Incorporating corrigendum July 2002 English version Sports mats - Part 1:
11、Gymnastic mats, safety requirements Tapis de sport - Partie 1: Tapis de gymnastique, exigences de scurit Sportmatten - Teil 1: Turnmatten, sicherheitstechnische Anforderungen This European Standard was approved by CEN on 21 January 2001. CEN members are bound to comply with the CEN/CENELEC Internal
12、Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Management Centre or to any CEN member. This
13、 European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions. CEN members are the n
14、ational standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHE
15、S KOMITEE FR NORMUNG Management Centre: rue de Stassart, 36 B-1050 Brussels 2001 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 12503-1:2001 E Page 2 EN 12503-1:2001 Contents Page Foreword .2 1 Scope 3 2 Normative references .3 3 T
16、erms and definitions .3 4 Classification 4 5 Safety requirements .4 6 Marking .5 Annex A (informative) Flame retardancy 6 Foreword This European Standard has been prepared by Technical Committee CEN/TC 136 “Sports, playground and other recreational equipment“, the secretariat of which is held by DIN
17、. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by October 2001, and conflicting national standards shall be withdrawn at the latest by October 2001. This standard EN 12503 “Sport mats“ consists of
18、: Part 1: Gymnastic mats, safety requirements Part 2: Pole vault and high jump mats, safety requirement Part 3: Judo mats, safety requirements Part 4: Determination of shock absorption Part 5: Determination of the base friction Part 6: Determination of the top friction Part 7: Determination of stati
19、c stiffness Annex A is informative. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy,
20、Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. Page 3 EN 12503-1:2001 1 Scope This Standard specifies safety requirements (including performance requirements) for 8 types of gymnastic mats used in school, training and competition, see clause 4. The perf
21、ormance and safety values cover shock absorption, anti-slip characteristics of the base and top friction characteristics of the surface. NOTE For the specific requirements of international official competitions, see appropriate international regulations. 2 Normative references This standard incorpor
22、ates, by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this standa
23、rd only when incorporated in it by amendment or revision. For undated references, the latest edition of the publication referred to applies (including amendments). EN 12503-4:2001 Sports mats Part 4: Determination of shock absorption EN 12503-5:2001 Sports mats Part 5: Determination of the base fric
24、tion EN 12503-6:2001 Sports mats Part 6: Determination of the top friction 3 Terms and definitions For the purposes of this standard the following terms and definitions apply: 3.1 shock absoprtion ability of the mat to reduce impact forces on the athlete, expressed as a maximum deceleration under de
25、fined test conditions 3.2 deflection ability of the mat to deform to an impact whilst maintaining the athletes stability, expressed as maximum deflection under defined test conditions 3.3 resilience ability of the mat to return energy after an impact, expressed as resilience in percent under defined
26、 test conditions 3.4 surface upper side of the mat on which the athete moves 3.5 base under side of the mat designed to be in contact with the floor during use Page 4 EN 12503-1:2001 4 Classification Gymnastic mats shall be classified by the design (types) as shown in table 1. Table 1 - Types TypeTy
27、pical use 1Mat for floor exercise without jumping (foundation skills) 2Mat for floor exercise with jumping 3Mat for floor exercise with jumping and landing 4Mat for simple dismount from apparatus with controlled landing 5Mat for dismount 6Mat for difficult dismount 7Fall mattress for simple exercise
28、s 8Fall mattress NOTE For types 9, 10 and 11 see EN 12503-2:2001, for type 12 see EN 12503-3:2001. 5 Safety requirements 5.1 Shock absorption When tested according to EN 12503-4:2001, the gymnastic mat shall comply with the values of table 2 according to the appropriate type. Table 2 - Shock absorpt
29、ion Type Peak deceleration g (1 g = 9,81 ms-2) Deflection mm Resilience % 1? 80not needednot needed 2? 65? 3520 to 60 3? 30? 50? 55 4? 40? 110? 50 5? 25? 110? 30 6? 14a ? 105a? 15a 7? 35? 185? 25 8? 20? 250? 25 a These are comparable figures to FIG (Fdration Internationale de Gymnastique) standards
30、from 1997 Page 5 EN 12503-1:2001 5.2 Base friction characteristics When tested in accordance with EN 12503-5:2001, the gymnastic mat shall comply with the values given in table 3. Table 3 - Base friction characteristics TypeFrictional value 1no requirement 2 ? 1,5 3 ? 1,5 4 ? 4,5 5 ? 4,5 6 ? 4,5 7 ?
31、 4,5 8 ? 4,5 5.3 Top friction characteristics When tested in accordance with EN 12503-6:2001, the gymnastic mat shall comply with the values of table 4. Table 4 - Top friction characteristics TypeFrictional value 1 ? 0,8 2 ? 0,8 3 ? 0,8 4 ? 0,8 5 ? 0,8 6 ? 0,8 7not needed 8not needed 6 Marking Mat s
32、hall be marked legibly and indelibly with the following information: a) the number of this European Standard EN 12503-1 and the type number; b) the name and trademark of the manufacturer, retailer or importer and the year of manufacture; c) which is the top surface of the mat (if not clearly recogni
33、zable). Page 6 EN 12503-1:2001 Annex A (informative) Flame retardancy Sports matting for use in the United Kingdom shall satisfy certain minimum levels of flame retardancy. These levels and the required test methodology are detailed in BS 1892: 2.10 : 1999 (revised). blank BS EN 12503-1:2001 BSI 389
34、 Chiswick High Road London W4 4AL BSI British Standards Institution BSI is the independent national body responsible for preparing British Standards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions British Standards are up
35、dated by amendment or revision. Users of British Standards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this Briti
36、sh Standard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel: +44 (0)20 8996 9000. Fax: +44 (0)20 8996 7400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically
37、receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel: +44 (0)20 8996 9001. Fax: +44 (0)20 8996 7001. Email: ordersbsi-. Standards are also available from the BSI website at http:/
38、www.bsi-. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as British Standards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international
39、 standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel: +44 (0)20 8996 7111. Fax: +44 (0)20 8996 7048. Email: infobsi-. Subscri
40、bing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel: +44 (0)20 8996 7002. Fax: +44 (0)20 8996 7001. Email: membershipbsi-. Information
41、regarding online access to British Standards via British Standards Online can be found at http:/www.bsi- Further information about BSI is available on the BSI website at http:/www.bsi-. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications
42、 of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise without prior written permission
43、from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. Details and advice can be obtained from the Copyright & Licensing Manager. Tel: +44 (0)20 8996 7070. Fax: +44 (0)20 8996 7553. Email: copyrightbsi-.