《BS-EN-1582-1996.pdf》由会员分享，可在线阅读，更多相关《BS-EN-1582-1996.pdf（16页珍藏版）》请在三一文库上搜索。
1、BRITISH STANDARD BS EN 1582:1996 EDI Message Booking confirmation message (IFTMBC) The European Standard EN 1582:1995 has the status of a British Standard ICS 35.240.60 Licensed Copy: sheffieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN 1582:1996 This Bri
2、tish Standard, having been prepared under the direction of the Information Systems Technology Assembly, was published under the authority of the Standards Board and comes into effect on 15 March 1996 BSI 01-2000 The following BSI references relate to the work on this standard: Committee reference IS
3、T/14 Draft for comment 94/646104 DC ISBN 0 580 25137 3 Committees responsible for this British Standard The preparation of this British Standard was entrusted to Technical Committee IST/14, Electronic Data Interchange, upon which the following bodies were represented: Association for Payment Clearin
4、g Services (APACS) British Telecommunications plc CCTA (the Government Centre for Information Systems) Computing Services and Software Association EDI Association NHS (Information Management Centre) NHS (Management Executive) PC Security Ltd. Simpler Trade Procedures Board Co-opted Members Amendment
5、s issued since publication Amd. No.DateComments Licensed Copy: sheffieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN 1582:1996 BSI 01-2000i Contents Page Committees responsibleInside front cover National forewordii Foreword2 Text of EN 15823 Licensed Copy:
6、 sheffieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN 1582:1996 ii BSI 01-2000 National foreword This British Standard has been prepared by Technical Committee IST/14 and is the English language version of EN 1582:1995 EDI Message Booking confirmation mes
7、sage (IFTMBC), published by the European Committee for Standardization (CEN). This British Standard is published under the direction of the Information Systems Technology Assembly whose Technical Committee IST/14 has the responsibility to: aid enquirers to understand the text; present to the respons
8、ible international committee any enquiries on interpretation, or proposals for change, and keep UK interests informed; monitor related international and European developments and promulgate them in the UK. NOTEInternational and European Standards, as well as overseas standards, are available from Cu
9、stomer Services, BSI, 389 Chiswick High Road, London W4 4AL. A British Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from
10、 legal obligations. Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, the EN title page, pages 2 to 10 and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment
11、table on the inside front cover. Licensed Copy: sheffieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 1582 April 1995 ICS 35.240.60 Descriptors: Information interchange, data transmission, transportation, frei
12、ght transport, messages, common transaction language, user supplier relations English version EDI Message Booking confirmation message (IFTMBC) EDI Message Confirmation de rservationEDI Nachricht Buchungs-/ Reservierungsbesttigung (IFTMBC) This European Standard was approved by CEN on 1995-03-11. CE
13、N members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on app
14、lication to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has
15、 the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CEN European Committee for Stand
16、ardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1995 All rights of reproduction and communication in any form and by any means reserved in all countries to CEN and its members. Ref. No. EN 1582:1995 E Licensed Copy: sh
17、effieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN 1582:1995 BSI 01-2000 2 Foreword This European Standard has been taken over by CEN from the Western European EDIFACT Board in the UN/EDIFACT context. This European Standard shall be given the status of a nat
18、ional standard, either by publication of an identical text or by endorsement, at the latest by October 1995, and conflicting national standards shall be withdrawn at the latest by October 1995. According to the CEN/CENELEC Internal Regulations, the following countries are bound to implement this Eur
19、opean Standard: Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. This message standard shall be used in conjunction with EN 1475:1995, Supporting Directory based on UN/E
20、DIFACT D.93A Directory. For reference to codes (which are not part of this or any other standard) refer to WE/EB Secretariat ECE DG III B/5, rue de la Loi 200, 1049 Brussels. This standard is technically identical to the corresponding UN/EDIFACT recommendation. Contents Page Foreword2 1Scope3 2Norma
21、tive references3 3Definitions3 4Requirements3 4.1Data segment clarification3 4.2Message structure6 4.2.1Branching diagram6 4.2.2Segment table7 4.3Data segment index7 Annex A (informative) Additional information9 A.1Field of application9 A.2Principles9 Annex B (informative) Example10 Table 1 Segment
22、table7 Licensed Copy: sheffieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN 1582:1995 BSI 01-20003 1 Scope This specification provides the definition of the Booking Confirmation Message (IFTMBC) to be used in Electronic Data Interchange (EDI) between partners
23、 involved in Administration, Commerce and Transport. This paper provides the definition of the Booking Confirmation Message to be used in fulfilling the requirements of trading partners in the transport chain worldwide, in the interchange of cargo and transport related information using Electronic D
24、ata Interchange (EDI). This message is a single consignment based message, being aligned with other single consignment based messages such as the other two booking messages (IFTMBP and IFTMBF), the instruction messages (IFTMIN and IFTMCS) and the Arrival Notice Message (IFTMAN). The single consignme
25、nt based messages can be used by all modes of transport for the forwarding and transport of goods from any origin to any destination, regardless of route or prevailing commercial practice. These messages are suitable for the arrangement of the transport of goods between all parties to the movement o
26、f the consignment (including the consignor/shipper and consignee as well as the forwarders, brokers, and carriers involved) as well as providing the information necessary to perform that transport and delivery of the goods. They should be used in the same way by each mode of transport when the requi
27、rements are common, even if functionally similar information is known by different names. A message from the party providing forwarding and/or transport services to the party booking those services giving the confirmation information to the booking of the consignment concerned. A confirmation might
28、read that the booking of a consignment is accepted, pending, conditionally accepted or rejected. The conditions under which requested services take place may be given in this message. 2 Normative references This standard incorporates by dated or undated reference, provisions from other publications.
29、 These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this standard only when incorporated in it by amendment or revision. For undated re
30、ferences the latest edition of the publication referred to applies. UNTDID UN Trade Data Interchange Directory, Issue UN/ECE/TRADE/WP.4/R.1016, Part 4, UN/ECE UNSM General Introduction1). 3 Definitions For the purposes of this standard, the following definitions apply: UNTDID (see normative referenc
31、e) 4 Requirements 4.1 Data segment clarification This section should be read in conjunction with the Branching Diagram and the Segment Table which indicate mandatory, conditional and repeating requirements. UNH, Message header A service segment starting and uniquely identifying the message. NOTEBook
32、ing Confirmation Messages conforming to this document must contain the following data in segment UNH, composite S009: BGM, Beginning of message A segment to indicate the beginning of a message and to transmit identifying number and type of the message. 1) Information about sources of supply can be o
33、btained from WE/EB Secretariat CEC DG III B/5, rue de la Loi 200, 1049 Brussels. Data element0065 IFTMBC 0052 D 0054 93A 0051 UN Licensed Copy: sheffieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN 1582:1995 4 BSI 01-2000 CTA, Contact information A segment to
34、 identify a person or department to whom communication should be directed. COM, Communication contact A segment to identify a communication number of a person or department to whom communication should be directed. DTM, Date/time/period A segment to indicate a date and time applying to the whole mes
35、sage, e.g. date and time of document issue. FTX, Free text A segment to specify free form or processable supplementary information, such as status of transport, remarks to be printed on the transport documents (where required), consignment remarks, insurance instructions, etc., or any other addition
36、al information. CNT, Control total A segment to specify totals for a consignment. Segment Group 1: LOC-DTM A group of segments to specify locations and related date(s)/time(s) which apply to the entire message, e.g. place of transshipment. LOC, Place/location identification A segment to identify a l
37、ocation applying to the entire message. DTM, Date/time/period A segment to indicate date(s) and time(s) relating to the location. Segment Group 2: RFF-DTM A group of segments containing a reference and constants which apply to the entire message. RFF, Reference A segment to express a reference which
38、 applies to the entire message such as: the document/message number that is to be updated by this very message (according to data element 1225 Message Function, coded in segment BGM), booking reference, order number, insurance contract, etc. DTM, Date/time/period A segment to indicate date and time
39、relating to the reference. Segment Group 3: TDT-DTM-TSR-LOC-SG4 A group of segments to indicate details of the movement of goods such as mode and means of transport, locations, departure, and arrival date(s) and time(s). TDT, Details of transport A segment to indicate information related to a certai
40、n stage of the transport, such as mode, means and carrier. DTM, Date/time/period A segment to indicate departure/arrival date and time. TSR, Transport service requirements A segment to identify contract, conditions of carriage, services, priority requirements for this stage of transport. LOC, Place/
41、location identification A segment to indicate a location such as origin, destination, stop off, etc., related to this leg of transport. Segment Group 4: RFF-DTM A group of segments to specify an additional reference related to the stage of the transport. RFF, Reference A segment to specify the addit
42、ional reference. DTM, Date/time/period A segment to identify date and time relating to the reference. Segment Group 5: NAD-LOC A group of segments to identify a party, related references, locations contacts, required documents, and charges to be paid by the party. NAD, Name and address A segment to
43、identify the partys name, address, and function. LOC, Place/location identification A segment to indicate a location where a specific function will be performed. Licensed Copy: sheffieldun sheffieldun, na, Fri Nov 17 07:57:14 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN 1582:1995 BSI 01-20005 Segme
44、nt Group 6: GID-HAN-TMP-RNG-TMD- LOC-FTX-SG7-SG8-SG9-SG10-SG11-SG12-SG13 A group of segments to describe the goods items for which transport is undertaken. GID, Goods item details A segment to identify a goods item for which transport is undertaken. A goods item can be identified by up to three leve
45、ls of packaging. HAN, Handling instructions A segment to specify handling instructions relating to the goods item. TMP, Temperature A segment to specify a temperature setting for a goods item. RNG, Range details A segment to specify a temperature range setting for a goods item. TMD, Transport moveme
46、nt details A segment to specify transport movement details for a goods item. LOC, Place/location identification A segment to specify a country associated with a goods item, such as country of origin, or country of destination. FTX, Free text A segment to specify processable supplementary information
47、 relating to the goods item. Segment Group 7: NAD-DTM A group of segments to identify different places of collection and/or delivery for the goods item. NAD, Name and address A segment to specify an address of a place of collection or delivery for a goods item. DTM, Date/time/period A segment to ind
48、icate date and time relating to the place of collection or delivery. Segment Group 8: GDS-FTX A group of segments to describe the goods item. GDS, Nature of cargo A segment to describe the nature of cargo. FTX, Free text A segment to describe the goods item. Segment Group 9: MEA-EQN A group of segme
49、nts to specify measurements applicable to a goods item. MEA, Measurements A segment to specify measurements, other than dimensions, applicable to a goods item. EQN, Number of units A segment to specify the number of equipment units to each of which the given measurement applies. Segment Group 10: DIM-EQN A group of segments to specify dimensions applicable to a goods item. DIM, Dimensions A segment to specify dimensions applicable to a goods item. EQN, Number of units A segment to specify the number of equipment units to each of wh