《IEC-61753-062-6-2007.pdf》由会员分享，可在线阅读，更多相关《IEC-61753-062-6-2007.pdf（32页珍藏版）》请在三一文库上搜索。
1、 INTERNATIONAL STANDARD IEC CEI NORME INTERNATIONALE 61753-062-6 First edition Premire dition 2007-07 Fibre optic interconnecting devices and passive components performance standard Part 062-6: Non-connectorized single-mode fibre optic pigtailed isolators for category O Uncontrolled environment and
2、sequential test Norme de qualit de fonctionnement des dispositifs dinterconnexion et composants passifs fibres optiques Partie 062-6: Isolateurs fibres optiques monomodales fibre amorce non connectoriss pour la catgorie O Environnement non contrl et essai squentiel Reference number Numro de rfrence
3、IEC/CEI 61753-062-6:2007 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:39:53 MDTNo reproduction or networking permitted without license from IHS -,-,- THIS PUBLICATION IS CO
4、PYRIGHT PROTECTED Copyright 2007 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either
5、IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits
6、de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI ou du Comit national de la CEI du
7、 pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office 3, rue de Varemb CH-1211 Geneva
8、20 Switzerland Email: inmailiec.ch Web: www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical co
9、ntent of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. ? Catalogue of IEC publications: www.iec.ch/searchpub The IEC on-line Catalogue enables you to search by a variety of criteri
10、a (reference number, text, technical committee,). It also gives information on projects, withdrawn and replaced publications. ? IEC Just Published: www.iec.ch/online_news/justpub Stay up to date on all new IEC publications. Just Published details twice a month all new publications released. Availabl
11、e on-line and also by email. ? Customer Service Centre: www.iec.ch/webstore/custserv If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service Centre FAQ or contact us: Email: csciec.ch Tel.: +41 22 919 02 11 Fax: +41 22 919 03 00 A propos
12、 de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique des publications de
13、 la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. ? Catalogue des publications de la CEI: www.iec.ch/searchpub/cur_fut-f.htm Le Catalogue en-ligne de la CEI vous permet deffectuer des recherches en utilisant
14、diffrents critres (numro de rfrence, texte, comit dtudes,). Il donne aussi des informations sur les projets et les publications retires ou remplaces. ? Just Published CEI: www.iec.ch/online_news/justpub Restez inform sur les nouvelles publications de la CEI. Just Published dtaille deux fois par mois
15、 les nouvelles publications parues. Disponible en-ligne et aussi par email. ? Service Clients: www.iec.ch/webstore/custserv/custserv_entry-f.htm Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions, visitez le FAQ du Service clients ou contactez-nous: Email
16、: csciec.ch Tl.: +41 22 919 02 11 Fax: +41 22 919 03 00 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:39:53 MDTNo reproduction or networking permitted without license from I
17、HS -,-,- INTERNATIONAL STANDARD IEC CEI NORME INTERNATIONALE 61753-062-6 First edition Premire dition 2007-07 Fibre optic interconnecting devices and passive components performance standard Part 062-6: Non-connectorized single-mode fibre optic pigtailed isolators for category O Uncontrolled environm
18、ent and sequential test Norme de qualit de fonctionnement des dispositifs dinterconnexion et composants passifs fibres optiques Partie 062-6: Isolateurs fibres optiques monomodales fibre amorce non connectoriss pour la catgorie O Environnement non contrl et essai squentiel N Commission Electrotechni
19、que Internationale International Electrotechnical Commission PRICE CODE CODE PRIX For price, see current catalogue Pour prix, voir catalogue en vigueur Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not f
20、or Resale, 07/16/2007 00:39:53 MDTNo reproduction or networking permitted without license from IHS -,-,- 2 61753-062-6 IEC:2007 CONTENTS FOREWORD.3 1 Scope.6 2 Normative references6 3 Test7 4 Test report8 5 Performance requirements8 5.1 Sample size, sequencing and grouping 8 5.2 Test details and req
21、uirements8 Annex A (normative) Sequencing and grouping of tests 14 Bibliography15 Table 1 Single-mode spectral bands.8 Table 2 Test details and requirements9 Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie
22、 Not for Resale, 07/16/2007 00:39:53 MDTNo reproduction or networking permitted without license from IHS -,-,- 61753-062-6 IEC:2007 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ FIBRE OPTIC INTERCONNECTING DEVICES AND PASSIVE COMPONENTS PERFORMANCE STANDARD Part 062-6: Non-connectorized single-mode
23、fibre optic pigtailed isolators for category O Uncontrolled environment and sequential test FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC
24、 is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS)
25、and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising with t
26、he IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearl
27、y as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that
28、sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees
29、undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC provides no marking procedu
30、re to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents
31、 including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or
32、 reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of
33、the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 61753-062-6 has been prepared by subcommittee 86B: Fibre optic interconnecting devices and passive components, of IEC
34、technical committee 86: Fibre optics. The text of this standard is based on the following documents: FDIS Report on voting 86B/2529/FDIS 86B/2579/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. Copyright Internat
35、ional Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:39:53 MDTNo reproduction or networking permitted without license from IHS -,-,- 4 61753-062-6 IEC:2007 This publication has been drafted in accor
36、dance with the ISO/IEC Directives, Part 2. A list of all parts of the IEC 61753 series, published under the general title Fibre optic interconnecting devices and passive components performance standard, can be found on the IEC website. The committee has decided that the contents of this publication
37、will remain unchanged until the maintenance result date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. Copyright International Electr
38、otechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:39:53 MDTNo reproduction or networking permitted without license from IHS -,-,- 61753-062-6 IEC:2007 5 NOTICE This document contains material that is Copyrig
39、ht 2006, Telcordia Technologies, Inc. (“Telcordia“). All rights reserved. The reader is advised that this IEC document and Telcordia source(s) may differ, and the context and use of said material in this IEC document may differ from that of Telcordia. TELCORDIA MAKES NO REPRESENTATION OR WARRANTY, E
40、XPRESS OR IMPLIED, WITH RESPECT TO THE SUFFICIENCY, ACCURACY, OR UTILITY OF ANY INFORMATION OR OPINION CONTAINED HEREIN. ANY USE OF OR RELIANCE UPON SAID INFORMATION OR OPINION IS AT THE RISK OF THE USER. TELCORDIA SHALL NOT BE LIABLE FOR ANY DAMAGE OR INJURY INCURRED BY ANY PERSON ARISING OUT OF TH
41、E SUFFICIENCY, ACCURACY, OR UTILITY OF ANY INFORMATION OR OPINION CONTAINED HEREIN. Copyright International Electrotechnical Commission Provided by IHS under license with IECLicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 07/16/2007 00:39:53 MDTNo reproduction or networking perm
42、itted without license from IHS -,-,- 6 61753-062-6 IEC:2007 FIBRE OPTIC INTERCONNECTING DEVICES AND PASSIVE COMPONENTS PERFORMANCE STANDARD Part 062-6: Non-connectorized single-mode fibre optic pigtailed isolators for category O Uncontrolled environment and sequential test 1 Scope This part of IEC 6
43、1753 contains the minimum test and measurement requirements and severities which a fibre optic isolator must satisfy in order to be categorized as meeting the requirements of isolator devices used in outside plant environments. The requirements cover non-connectorized single-mode fibre optic pigtail
44、ed isolators for category O used in an uncontrolled environment and a sequential test. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of
45、 the referenced document (including any amendments) applies. IEC 60793-1-1, Optical fibres Part 1-1: Measurement methods and test procedures General and guidance IEC 61300-2-1, Fibre optic interconnecting devices and passive components Basic test and measurement procedures Part 2-1: Tests Vibration
46、(sinusoidal) IEC 61300-2-4, Fibre optic interconnecting devices and passive components Basic test and measurement procedures Part 2-4: Tests Fibre/cable retention IEC 61300-2-5, Fibre optic interconnecting devices and passive components Basic test and measurement procedures Part 2-5: Tests Torsion/t
47、wist IEC 61300-2-9, Fibre optic interconnecting devices and passive components Basic test and measurement procedures Part 2-9: Tests Shock IEC 61300-2-14, Fibre optic interconnecting devices and passive components Basic test and measurement procedures Part 2-14: Tests Optical power handling and dama
48、ge threshold characterization IEC 61300-2-19, Fibre optic interconnecting devices and passive components Basic test and measurement procedures Part 2-19: Tests Damp heat (steady state) IEC 61300-2-22, Fibre optic interconnecting devices and passive components Basic test and measurement procedures Part 2-22: Tests C