《ISO-11125-6-1993.pdf》由会员分享,可在线阅读,更多相关《ISO-11125-6-1993.pdf(7页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD IS0 111256 First edition 1993-l 2-l 5 Preparation of steel substrates before application of paints and related products - Test methods for metallic blast-cleaning abrasives - Part 6: Determination of foreign matter Pkparation des subjectiles dacier avant application de peintur
2、es et de produits assimik - MBthodes dessai pour abrasifs mktalliques destines B la pr b) a reference to this part of IS0 11125 (IS0 11125-6); c) the result of the test; d) any deviation from the test method specified; 6.5 When all the apparently metallic material has been extracted from the sample,
3、 spread the residue in a thin layer on the paper and pass the magnet over the surface again to remove any remaining magnetic particles. e) the date of the test; f) the name of the person who carried out the test. Copyright International Organization for Standardization Provided by IHS under license
4、with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/27/2007 03:49:50 MDTNo reproduction or networking permitted without license from IHS -,-,- Q IS0 IS0 11125-6:1993(E) Annex A (informative) International Standards for metallic blast-cleaning abrasives Requirements and test me
5、thods for metallic blast- cleaning abrasives are contained in IS0 11124 and IS0 11125, respectively. IS0 11124 will consist of the following parts, under the general title: Preparation of steel substrates before application of paints and related products - Specification for metallic blast-cleaning a
6、brasives - Part 1: General introduction and classification - Part 2: Chilled-iron grit - Part 3: High-carbon cast-steel shot and grit - Part 4: Low-carbon cast-steel shot - Part 5: Cut steel wire IS0 11125 will consist of the following parts, under the general title: Preparation of steel substrates
7、before application of paints and related products - Test methods for metallic blast-cleaning abrasives - Part 1: Sampling - Part 2: Determination of particle size distri- bution - Part 3: Determination of hardness - Part 4: Determination of apparent density - Part 5: Determination of percentage defe
8、ctive particles and of microstructure - Part 6: Determination of foreign matter - Part 7: Determination of moisture - Part 8: Determination of abrasive mechanical properties 3 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Stan
9、dards 1/9972545001 Not for Resale, 04/27/2007 03:49:50 MDTNo reproduction or networking permitted without license from IHS -,-,- IS0 11125-6:1993(E) UDC 667.648.1:621.7.023:621.921.1:620.192.4 Descriptors: paints, varnishes, substrates, steel products, blast-cleaning, abrasives, metallic abrasives,
10、tests, determination, contaminants. Price based on 3 paaes Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/27/2007 03:49:50 MDTNo reproduction or networking permitted without license from IHS -,-,-