《ISO-15938-7-AMD-1-2005.pdf》由会员分享，可在线阅读，更多相关《ISO-15938-7-AMD-1-2005.pdf（12页珍藏版）》请在三一文库上搜索。
1、 Reference number ISO/IEC 15938-7:2003/Amd.1:2005(E) ISO/IEC 2005 INTERNATIONAL STANDARD ISO/IEC 15938-7 First edition 2003-12-01 AMENDMENT 1 2005-07-15 Information technology Multimedia content description interface Part 7: Conformance testing AMENDMENT 1: Conformance extensions Technologies de lin
2、formation Description de linterface du contenu multimdia Partie 7: Essais de conformit AMENDEMENT 1: Extensions de conformit Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55
3、:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 15938-7:2003/Amd.1:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces wh
4、ich are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems I
5、ncorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
6、 that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO/IEC 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocop
7、ying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzer
8、land ii ISO/IEC 2005 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IE
9、C 15938-7:2003/Amd.1:2005(E) ISO/IEC 2005 All rights reserved iii Foreword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC partic
10、ipate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental
11、 and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. T
12、he main task of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies
13、 casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying any or all such patent rights. Amendment 1 to ISO/IEC 15938-7:2003 was prepared by Joint Technical Committe
14、e ISO/IEC JTC 1, Information technology, Subcommittee SC 29, Coding of audio, picture, multimedia and hypermedia information. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:5
15、5:04 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted
16、 without license from IHS -,-,- ISO/IEC 15938-7:2003/Amd.1:2005(E) ISO/IEC 2005 All rights reserved 1 Information technology Multimedia content description interface Part 7: Conformance testing AMENDMENT 1: Conformance extensions In subclause 5.6.3, Definition of Reference Textual Access Unit Form D
17、escriptions, add the following items to the list: ? FUContext: dynamic insertion of elements using insert command ? FU payload: deferred and non deferred fragment references In subclause 5.9.2, Definition of Reference Binary Access Unit Form Descriptions, add the following items to list to the list:
18、 ? DecoderInit: Optimized decoder initialisation, fragment references and multiple payload with rationale position codes ? FUContext: dynamic insertion of elements using rationale position codes ? FU context: mixed content model ? FU payload: dynamical configurable optimized decoders ? FU payload: m
19、ultiple assignment of optimized decoders for a single type ? FU payload: mixed content model ? FU payload: deferred and non deferred fragment references In subclause 6.5.1.1, Systems BiM Conformance Bitstreams, add the following items to Table 1 and corresponding bitstreams: Table 1 summarizes the S
20、ystems BiM conformance bistreams. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 15938
21、-7:2003/Amd.1:2005(E) 2 ISO/IEC 2005 All rights reserved Table 1 Systems BiM Conformance Bistreams Conformance Stream Decoder Init Fragment Updates Context Path Commands Payload Descr Multiple Fragments Schema References Fragment Updates Type Address Add Delete Replace Reset Deferred Nodes BiM_Audio
22、_Unifor mQuantization_ 1.bin BiM_Audio_Unifor mQuantization_ 2.bin Single Absolute root ? BiM_Audio_NonUni formQuantization _1.bin BiM_Audio_NonUni formQuantization _2.bin Single Absolute root ? BiM_XML_Absolute ContextPath_Mix edContent_1.bin BiM_XML_Absolute ContextPath_Mix edContent_2.bin Single
23、Absolute mixe d text ? BiM_XML_Relative ContextPath_Mix edContent_1.bin BiM_XML_Relative ContextPath_Mix edContent_2.bin Single relative mixe d text ? BiM_MDS_Ration aleMultiplePay load_1.bin BiM_MDS_Ration aleMultiplePay load_2.bin Single Absolute root ? BiM_MDS_Zlib_ 1.bin BiM_MDS_Zlib_ 2.bin Sing
24、le Absolute root ? Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 15938-7:2003/Amd.1:2
25、005(E) ISO/IEC 2005 All rights reserved 3 Conformance Stream Decoder Init Fragment Updates Context Path Commands Payload Descr Multiple Fragments Schema References Fragment Updates Type Address Add Delete Replace Reset Deferred Nodes BiM_XML_Payload _MixedContent_1 .bin BiM_XML_Payload _MixedContent
26、_ 2.bin Single Absolute root ? BiM_MDS_Rationa lPositionCode_ 1.bin BiM_MDS_Rationa lPositionCode_ 2.bin Single Absolute elem ent ? BiM_MDS_Deferre dFragmentRefere nce_1.bin BiM_MDS_Deferre dFragmentRefere nce_2.bin Single Absolute frag ment refer ence ? BiM_MDS_NonDefe rredFragmentRef erence_1.bin
27、BiM_MDS_NonDefe rredFragmentRef erence_2.bin Single Absolute frag ment refer ence ? In subclause 6.5.1.2, Systems TeM Conformance Bitstreams, add the “INSERT“ column to Table 2: In subclause 6.5.1.2, add the following items to Table 2 and corresponding bitstreams: Table 2 summarizes the Systems TeM
28、conformance bistreams. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 15938-7:2003/Amd
29、.1:2005(E) 4 ISO/IEC 2005 All rights reserved Table 2 Systems TeM Conformance Bistreams Conformance Stream Decoder Init Fragment Updates Context Path Commands Payload Initial Descr Multiple Fragments Schema References Fragment Updates Type Address Add Delete Replace Reset Insert Deferred Nodes descr
30、iption098 attribute- systems.xml ? ? Single Bot h Bot h ? ? ? ? TeM_MDS_Deferre dFragmentRefere nce_1.bin TeM_MDS_Deferre dFragmentRefere nce_2.bin Single Abs olut e frag men t refe renc e ? TeM_MDS_NonDefe rredFragmentRef erence_1.bin TeM_MDS_NonDefe rredFragmentRef erence_2.bin Single Abs olut e f
31、rag men t refe renc e ? TeM_MDS_InsertC ommand_1.bin TeM_MDS_InsertC ommand_2.bin Single Abs olut e ele men t ? Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo rep
32、roduction or networking permitted without license from IHS -,-,- ISO/IEC 15938-7:2003/Amd.1:2005(E) ISO/IEC 2005 All rights reserved 5 In subclause 7.3.4, Naming Scheme for Visual Conformance Descriptions, add the following items to Table 3 and corresponding bitstreams: Table 3 Naming Scheme for Vid
33、eo Conformance Descriptions Descriptor/Descriptionscheme Basename GofGopFeature GofGopFeature Color Temperature Color Temperature IlluminationInvariantColor IlluminationInvariantColor Shape Variation Shape Variation AdvancedFaceRecognition AdvancedFaceRecognition StillRegionFeature StillRegionFeatur
34、e VideoSegmentFeature VideoSegmentFeature MovingRegionFeature MovingRegionFeature In subclause 7.4.3, Naming Scheme for Conformance Descriptions, add the following items to Table 4 and corresponding bitstreams: Table 4 Naming Scheme for Audio Conformance Descriptions Descriptor/Descriptionscheme Bas
35、ename AudioBpmD AudioBpm AudioSignalQualityDS AudioSignalQualityDS BackgroundNoiseLevelD BackgroundNoiseLevel BalanceD Balance BandwidthD Bandwidth CrossChannelCorrelationD CrossChannelCorrelation DCOffsetD DCOffset RelativeDelayD RelativeDelay Copyright International Organization for Standardizatio
36、n Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 15938-7:2003/Amd.1:2005(E) 6 ISO/IEC 2005 All rights reserved In subclause 7.5.7, MDS Conforma
37、nce Descriptions, add the following items to Table 5 and corresponding bitstreams: Table 5 Naming Scheme for MDS Conformance Descriptions MDS Top-level Type Conformance Description: AudioType AudioType_XXX.xml ClassificationSchemeDescriptionType ClassificationSchemeDescriptionType_XXX.xml Linguistic
38、Type LinguisticType_XXX.xml MultimediaType MultimediaType_XXX.xml TextType TextType_XXX.xml Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or network
39、ing permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- IS
40、O/IEC 15938-7:2003/Amd.1:2005(E) ICS 35.040 Price based on 6 pages ISO/IEC 2005 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,-