《ISO-22702-AMD-1-2008.pdf》由会员分享，可在线阅读，更多相关《ISO-22702-AMD-1-2008.pdf（10页珍藏版）》请在三一文库上搜索。
1、 Reference number ISO 22702:2003/Amd.1:2008(E) ISO 2008 INTERNATIONAL STANDARD ISO 22702 First edition 2003-11-01 AMENDMENT 1 2008-09-15 Utility lighters General consumer- safety requirements AMENDMENT 1: Clarification of requirements and addition of safety symbols Briquets utilitaires Exigences gnr
2、ales pour la scurit des consommateurs AMENDEMENT 1: Clarification des exigences et ajout de symboles de scurit Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or netwo
3、rking permitted without license from IHS -,-,- ISO 22702:2003/Amd.1:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and
4、installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software
5、products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is fou
6、nd, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and mic
7、rofilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO
8、2008 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22702:2003/Amd.1:2008(E) ISO 2008 A
9、ll rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in
10、a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commissi
11、on (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical c
12、ommittees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall n
13、ot be held responsible for identifying any or all such patent rights. Amendment 1 to ISO 22702:2003 was prepared by Technical Committee ISO/TC 61, Plastics. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 1
14、0/25/2008 04:54:21 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted wi
15、thout license from IHS -,-,- ISO 22702:2003/Amd.1:2008(E) ISO 2008 All rights reserved 1 Utility lighters General consumer-safety requirements AMENDMENT 1: Clarification of requirements and addition of safety symbols IMPORTANT The electronic file of this document contains colours which are considere
16、d to be useful for the correct understanding of the document. Users should therefore consider printing this document using a colour printer. Page 7 4.3.2 Utility lighters that meet the requirements of 4.3.1 and that are still able to be ignited in the intended manner after stabilization at (23 2) C
17、shall subsequently meet all the applicable requirements of 3.1 to 3.5, inclusive. Page 8 6.1.1 General All utility lighters shall be accompanied by appropriate safety information (instructions or warnings, or both), in either text form or in the form of safety symbols that would replace all existing
18、 textual instructions and warnings, or both, communicating to the user the proper method of usage. Page 9 6.1.3.3 For all utility lighters, the safety information shall include the following as appropriate to the type of utility lighter. a) “Be sure flame is out after use”. b) “Never expose to heat
19、above 50 C or to prolonged sunlight”. c) “Never puncture or put in fire”. d) “Extreme heat is present above the visible flame. Extra care should be taken to prevent burns, injury or fire”. (This statement shall accompany all premixing burner lighters.) e) “Follow all instructions and warnings provid
20、ed by grill or other appliance manufacturers when using this product”. f) “Do not keep lit for more than 30 s”. g) “After refilling, wait 2 min before using lighter”. (This statement shall accompany all refillable utility lighters.) Copyright International Organization for Standardization Provided b
21、y IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22702:2003/Amd.1:2008(E) 2 ISO 2008 All rights reserved h) “Contains flammable gas under pressure”. i) “When filled, contains f
22、lammable gas under pressure”. Add new subclause 6.1.4 as follows. 6.1.4 Safety symbols 6.1.4.1 General If safety symbols are used, they shall be as given in 6.1.4.2 to 6.1.4.5. 6.1.4.2 “Warning” symbol Background: white. Triangular band: black or red. Graphical symbol: same colour as triangular band
23、 (black or red). The symbol shall have the same proportions as those indicated in Figure 4. The size shall be at least 10 mm. or Figure 4 “Warning” symbol 6.1.4.3 “Keep Away From Children” symbol Background: white. Circular band and diagonal bar: red. Graphical symbol: black. The symbol shall have t
24、he same proportions as those indicated in Figure 5. The size shall be at least 10 mm. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted without l
25、icense from IHS -,-,- ISO 22702:2003/Amd.1:2008(E) ISO 2008 All rights reserved 3 Figure 5 “Keep Away From Children” symbol 6.1.4.4 “Caution, risk of fire” symbol Background: white. Triangular band: black or red. Graphical symbol: same colour as triangular band (black or red). The symbol shall have
26、the same proportions as those indicated in Figure 6. The size shall be at least 10 mm. or Figure 6 “Caution, risk of fire” symbol 6.1.4.5 “Never expose to heat above 50 C or to prolonged sunlight” symbol Background: white. Circular band and diagonal bar: red. Graphical symbol: black. The symbol shal
27、l have the same proportions as those indicated in Figure 7. The size shall be at least 10 mm. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted w
28、ithout license from IHS -,-,- ISO 22702:2003/Amd.1:2008(E) 4 ISO 2008 All rights reserved Figure 7 “Never expose to heat above 50 C or to prolonged sunlight” symbol Page 10 7.1.4.3 Ignite the utility lighter, allow the flame to stabilize for approximately 1,0 s, then measure the flame height to the
29、nearest 5 mm by determining where the tip of the visible flame registers in relation to the scribed marks on the board behind the utility lighter, during a 5 s burn. In 7.2.3.5, replace “in accordance with Figure 4” with “in accordance with Figure 8”. Page 11 Renumber Figure 4 as Figure 8. Page 11 7
30、.3.4.2 Place the utility lighter against the flame height measurement apparatus with the flame directed vertically upward, ignite and adjust to the flame height specified in 3.5.1, 3.5.2 or 3.5.3, as applicable, then extinguish and allow to cool for at least 1 min. Then, orient the utility lighter i
31、n the 45 below horizontal attitude, ignite the utility lighter for the amount of time specified in 3.5.1, 3.5.2 or 3.5.3, then extinguish in the normal manner. Measure and record the time of any burning occurring after the extinguishing action. Afterburns in excess of the amount of time specified in
32、 3.5.1, 3.5.2 and 3.5.3 constitute a failure. To be consistent with 4.3.2 make the following changes (to 7.4.5.4, 7.5.5.8, 7.7.4.7 and 7.8.4.8). Page 12 7.4.5.4 Utility lighters that do not fail the test described in 7.4.5.1 to 7.4.5.3 and are able to be ignited in the intended manner shall subseque
33、ntly meet all the applicable requirements of 3.1 to 3.5, inclusive. Page 14 7.5.5.8 Utility lighters that are able to be ignited in the intended manner shall subsequently meet all the applicable requirements of 3.1 to 3.5, inclusive. Page 15 7.7.4.7 Utility lighters that are able to be ignited in th
34、e intended manner shall subsequently meet all the applicable requirements of 3.1 to 3.5, inclusive. Page 16 7.8.4.8 Utility lighters that are able to be ignited in the intended manner shall subsequently meet all the applicable requirements of 3.1 to 3.5, inclusive. Copyright International Organizati
35、on for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Li
36、censee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22702:2003/Amd.1:2008(E) ICS 97.180 Price based on 4 pages ISO 2008 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:54:21 MDTNo reproduction or networking permitted without license from IHS -,-,-