《ISO-362-1-CORR-1-2009.pdf》由会员分享，可在线阅读，更多相关《ISO-362-1-CORR-1-2009.pdf（2页珍藏版）》请在三一文库上搜索。
1、ICS 17.140.30; 43.020 Ref. No. ISO 362-1:2007/Cor.1:2009(E) ISO 2009 All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 362-1:2007 TECHNICAL CORRIGENDUM 1 Published 2009-05-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION Measurement
2、 of noise emitted by accelerating road vehicles Engineering method Part 1: M and N categories TECHNICAL CORRIGENDUM 1 Mesurage du bruit mis par les vhicules routiers en acclration Mthode dexpertise Partie 1: Catgories M et N RECTIFICATIF TECHNIQUE 1 Technical Corrigendum 1 to ISO 362-1:2007 was prep
3、ared by Technical Committee ISO/TC 43, Acoustics, Subcommittee SC 1, Noise. Page iii, Contents, Annex B Replace “ISO Guide 98 (GUM)” with “ISO/IEC Guide 98-3”. Page 2, Clause 2 Replace “ISO Guide 98:1995, Guide to the expression of uncertainty in measurement (GUM)” with “ISO/IEC Guide 98-3, Uncertai
4、nty of measurement Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)”. ISO 362-1:2007/Cor.1:2009(E) 2 ISO 2009 All rights reserved Page 17, 8.3.1.3.1 Insert a new paragraph after the first paragraph: “The value of awot test used in the determination of gear selection shall be
5、the average of the four awot test, j values during each valid measurement run.” Page 17, 8.3.1.3.2, paragraph 1, line 1 Replace “awot, i” with “awot test”. Page 21, 8.4.3.1 Replace Equation (25) with wot test(1)wot test(2)wot test(3)wot test(4) wot test 4 aaaa a + = (25) Page 22, 8.5: paragraph 1, line 6; paragraph 1, line 7; paragraph under c), line 2; Note (four times) Page 44, Annex B: Title; Clause B.1, line 4 (twice) Page 46, Clause B.3, first paragraph under Table B.1, line 2; Clause B.4; line 2 (twice) Replace “ISO Guide 98” with “ISO/IEC Guide 98-3”. -,-,-