《ISO-500-1-CORR-1-2005.pdf》由会员分享,可在线阅读,更多相关《ISO-500-1-CORR-1-2005.pdf(2页珍藏版)》请在三一文库上搜索。
1、ICS 65.060.10 Ref. No. ISO 500-1:2004/Cor.1:2005(E) ISO 2005 All rights reserved Printed in Switzerland INTERNATIONAL STANDARD ISO 500-1:2004 TECHNICAL CORRIGENDUM 1 Published 2005-04-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION Agricultural tractors
2、 Rear-mounted power take-off types 1, 2 and 3 Part 1: General specifications, safety requirements, dimensions for master shield and clearance zone TECHNICAL CORRIGENDUM 1 Tracteurs agricoles Prises de force montes larrire des types 1, 2 et 3 Partie 1: Spcifications gnrales, exigences de scurit, dime
3、nsions du bouclier protecteur et de la zone de dgagement RECTIFICATIF TECHNIQUE 1 Technical Corrigendum 1 to International Standard ISO 500-1:2004 was prepared by Technical Committee ISO/TC 23, Tractors and machinery for agriculture and forestry, Subcommittee SC 4, Tractors. Page 1, Clause 2 Replace
4、 the normative reference entry for ISO 5673-2 with the following, so as to correct its title. “ISO 5673-2, Agricultural tractors and machinery Power take-off drive shafts and power-input connection Part 2: Specification for use of PTO drive shafts, and position and clearance of PTO drive line and PI
5、C for various attachments” Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 02:36:38 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 500-1:2004/Cor.1:2005(E) 2 ISO 20
6、05 All rights reserved Page 2, Clause 7 Replace the second sentence of the paragraph by the following, with reference to Table 2. “In Table 2, in addition to dimension p of 360 mm for PTO type 3, the dimension of 290 mm is optionally allowed for tractor rear PTO to accommodate component attachments.
7、” Page 4, Table 2 Replace the text of table footnote “b” with the following. “In addition, 290 mm is optionally allowed for tractor rear PTO to accommodate component attachments.” Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 02:36:38 MDTNo reproduction or networking permitted without license from IHS -,-,-