《ISO-8384-2000.pdf》由会员分享，可在线阅读，更多相关《ISO-8384-2000.pdf（54页珍藏版）》请在三一文库上搜索。
1、Reference number Numro de rfrence ISO 8384:2000(E/F/R) ISO 2000 INTERNATIONAL STANDARD NORME INTERNATIONALE ISO 8384 Second edition Deuxime dition ooe 2000-07-01 Ships and marine technology Dredgers Vocabulary Navires et technologie maritime Dragues Vocabulaire oe exoo Copyright International Organi
2、zation for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:05:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 8384:2000(E/F/R) PDF disclaimer This PDF file may contain embedded typefa
3、ces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infring
4、ing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimi
5、zed for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. PDF Exonration de responsabilit Le prsent fichier PDF peut con
6、tenir des polices de caractres intgres. Conformment aux conditions de licence dAdobe, ce fichier peut tre imprim ou visualis, mais ne doit pas tre modifi moins que lordinateur employ cet effet ne bnficie dune licence autorisant lutilisation de ces polices et que celles-ci y soient installes. Lors du
7、 tlchargement de ce fichier, les parties concernes acceptent de fait la responsabilit de ne pas enfreindre les conditions de licence dAdobe. Le Secrtariat central de lISO dcline toute responsabilit en la matire. Adobe est une marque dpose dAdobe Systems Incorporated. Les dtails relatifs aux produits
8、 logiciels utiliss pour la cration du prsent fichier PDF sont disponibles dans la rubrique General Info du fichier; les paramtres de cration PDF ont t optimiss pour limpression. Toutes les mesures ont t prises pour garantir lexploitation de ce fichier par les comits membres de lISO. Dans le cas peu
9、probable o surviendrait un problme dutilisation, veuillez en informer le Secrtariat central ladresse donne ci-dessous. ISO 2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including
10、photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. / Droits de reproduction rservs. Sauf prescription diffrente, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme qu
11、e ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lISO ladresse ci-aprs ou du comit membre de lISO dans le pays du demandeur. / e aa oxae. E e aao oao, aa a aoe a e oe ooaa ooaa ao-o oe a-o eo exae ooo, a ooo o, e eaeoo eoo oa O, o
12、ooe oo oeo oe aoa o aee, aaeoo o ae, eeeo e oe-e O ae aeeoaoo. ISO copyright office Case postale 56 ? CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.ch Web www.iso.ch Printed in Switzerland/Imprim en Suisse/Oeaao ea ii ISO 2000 All rights reserved/Tous droits rser
13、vs/ PDF Oooee o oao ao a PDF oe oea eoae . ooe eo o Adobe, o a oe oeaa aoa, oao o e oe ee, a ee ae, oa ee o e oe ee ao a ooae x o e oee aoa. aee aoeo aa aeeoae oo oaa a e oeeo a oee eox o Adobe. ea eeaa O e ee ao oeeo o ooe. Adobe e oo ao Adobe Systems Incorporated. ea, ooe oao oeee ooae oa aoeo aa
14、PDF, o oooa e General Info aa; aae oa PDF ooa ea. e eoxoe e, o aaoa ooae ao ao e ea O. ex ax, oa o o oe ooa, oa ooa ea eeaa o ae, eeo e. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/0
15、7/2007 02:05:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 8384:2000(E/F/R) ISO 2000 All rights reserved/Tous droits rservs/ iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bod
16、ies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and
17、 non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives,
18、Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements o
19、f this International Standard may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. The English, French and German texts of International Standard ISO 8384 were prepared by the European Committee for Standardization (CEN) in collaborati
20、on with ISO Technical Committee TC 8, Ships and marine technology, Subcommittee SC 7, Inland navigation vessels, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). The Russian text was prepared by GOST R. Throughout the text of this standard, read “.thi
21、s European Standard.“ to mean “.this International Standard.“. This second edition cancels and replaces the first edition (ISO 8384:1991), which has been technically revised. Annex A of this International Standard is for information only. Copyright International Organization for Standardization Prov
22、ided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:05:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 8384:2000(E/F/R) iv ISO 2000 All rights reserved/Tous droits rservs/ Avant-propos LISO (Organisation int
23、ernationale de normalisation) est une fdration mondiale dorganismes nationaux de normalisation (comits membres de lISO). Llaboration des Normes internationales est en gnral confie aux comits techniques de lISO. Chaque comit membre intress par une tude a le droit de faire partie du comit technique cr
24、 cet effet. Les organisations internationales, gouvernementales et non gouvernementales, en liaison avec lISO, participent galement aux travaux. LISO collabore troitement avec la Commission lectrotechnique internationale (CEI) en ce qui concerne la normalisation lectrotechnique. Les Normes internati
25、onales sont rdiges conformment aux rgles donnes dans les Directives ISO/CEI, Partie 3. Les projets de Normes internationales adopts par les comits techniques sont soumis aux comits membres pour vote. Leur publication comme Normes internationales requiert lapprobation de 75 % au moins des comits memb
26、res votants. Lattention est appele sur le fait que certains des lments de la prsente Norme internationale peuvent faire lobjet de droits de proprit intellectuelle ou de droits analogues. LISO ne saurait tre tenue pour responsable de ne pas avoir identifi de tels droits de proprit et averti de leur e
27、xistence. Les textes anglais, franais et allemand de la Norme internationale ISO 8384 ont t labors par le Comit europen de normalisation (CEN) en collaboration avec le comit technique ISO/TC 8, Navires et technologie maritime, sous-comit SC 7, Bateaux de navigation intrieure, conformment lAccord de
28、coopration technique entre lISO et le CEN (Accord de Vienne). Le texte russe a t labor par le GOST R. Tout au long du texte de la prsente norme, lire la prsente norme europenne avec le sens de la prsente Norme internationale. Cette deuxime dition annule et remplace la premire dition (ISO 8384:1991),
29、 dont elle a fait lobjet dune rvision technique. Lannexe A de la prsente Norme internationale est donne uniquement titre dinformation. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/
30、2007 02:05:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 8384:2000(E/F/R) ISO 2000 All rights reserved/Tous droits rservs/ v ( O ) (-). . -, , , . , , . , (). , /, 3. , , - . 75 % -, . , . . , 8384 (E) / 8, aoeexoo,ooe7,aeeoaa,ooeo e E ( ). . . . . . aoee ooe ae ae
31、 aee eoe ae (O 8384:1991), . oee A eaooo ao oo oa. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:05:00 MDTNo reproduction or networking permitted without license from IHS -,
32、-,- ISO 8384:2000(E/F/R) vi ISO 2000 All rights reserved/Tous droits rservs/ Contents Page Foreword.viii 1Scope.2 2Normative references.2 3General concepts applicable to dredgers.4 4Terms relating to types of dredgers depending on methods of soil ex- traction or treatment .6 5Terms relating to metho
33、ds and equipment for removal of soil10 6Terms relating to methods and equipment for operating move- ments .16 7Terms relating to dredging pump unit and to soil-loosening equipment.20 8Terms relating to bucket assembly24 9Terms relating to types of dredgers defined by power plant .26 10Terms relating
34、 to controls and to monitoring and measuring instruments.30 11Terms relating to basic parameters of dredgers.32 Annex A (informative) Alphabetical index (English) .36 Sommaire Page Avant-propos.viii 1Domaine dapplication 2 2Rfrences normatives.2 3Notions gnrales relatives aux dragues 4 4Termes relat
35、ifs aux types de dragues en fonction des mthodes de lextraction ou du traitement des matriaux6 5Termes relatifs aux modes et aux moyens de refoulement des matriaux10 6Termes relatifs aux modes et aux moyens de mouvements dopration16 7Termes relatifs aux pompes d- blais et aux dispositifs dsagr- gate
36、ur.20 8Termes relatifs au dispositif godets 24 9Termes relatifs aux types de dragues en fonction du genre din- stallation nergtique26 10Termes relatifs aux moyens de commande et aux appareils de contrle et de mesure.30 11Termes relatifs aux principaux para- mtres des dragues32 Annexe A (informative)
37、 Index alphabtique (Franais) .38 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 02:05:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 8384:2000(E/F/R) ISO 2000 All rights reserved/Tous droits rservs/ vii . ix 1 3 2 3 3 , .5 4, - .7 5, - . 11 6, -