《SAE-AIR-1698A-1996-R2007.pdf》由会员分享,可在线阅读,更多相关《SAE-AIR-1698A-1996-R2007.pdf(2页珍藏版)》请在三一文库上搜索。
1、AEROSPACE INFORMATION REPORT AIR1698 REV. A Issued1980-12 Revised1996-10 Reaffirmed2007-08 Hose Assembly Identification Practices 1.SCOPE: This SAE Aerospace Information Report (AIR) is applicable to hose assemblies for which identification marking is not otherwise specified in procurement or perfor
2、mance standard or drawing. 1.1Purpose: To recommend the minimum identification marking requirements and identification methods for hose assemblies. 2.APPLICABLE DOCUMENTS: The following publication forms a part of this document to the extent specified herein. The latest issue of SAE publications sha
3、ll apply. In the event of conflict between the text of this document and references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. 2.1SAE Publications: Available fr
4、om SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. AS478Identification Marking Methods RATIONALE This document has been reaffirmed to comply with the SAE 5-Year Review policy. SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical
5、 and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which ti
6、me it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, ph
7、otocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org Copyright SAE International Provid
8、ed by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:27:28 MSTNo reproduction or networking permitted without license from IHS -,-,- SAE AIR1698 Revision A - 2 - 3.IDENTIFICATION REQUIREMENTS: The hose assembly shall be identified with the following as
9、 a minimum (see Table 1): TABLE 1 - Identification Requirements 3.METHOD OF IDENTIFICATION: The hose assembly shall have all identification marking permanently marked per AS478 on a permanent stainless steel band or on the end fittings. The band shall not be more than 1.0 inches wide, shall be so de
10、signed to remain tight on the hose to prevent relative movement and resultant chafing, and of sufficient strength to prevent removal by hand. The characters shall be a minimum size of 1/16 inch. PREPARED BY SAE SUBCOMMITTEE G-3D, AEROSPACE HOSE OF COMMITTEE G-3, AEROSPACE COUPLINGS, FITTINGS, HOSE & TUBING ASSEMBLIES Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:27:28 MSTNo reproduction or networking permitted without license from IHS -,-,-