《SAE-AS-39029-36-2000-R2007.pdf》由会员分享，可在线阅读，更多相关《SAE-AS-39029-36-2000-R2007.pdf（3页珍藏版）》请在三一文库上搜索。
1、Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUME
2、NT ORDER:Tel: 877-606-7323 (inside USA and Canada)Tel: 724-776-4970 (outside USA) Fax: 724-776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.org SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering scie
3、nces. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirm
4、ed, revised, or cancelled. SAE invites your written comments and suggestions. SHEET 1 OF 3 AS39029/36 THIRD ANGLE PROJECTION AEROSPACE STANDARD AS39029/36 ISSUED 2000-07 REAFFIRMED 2007-06 CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-28748/9 CONNECTORS) PREPARED BY SAE SUBCOMMITTE
5、E AE-8C1 FEDERAL SUPPLY CLASS 5935 RATIONALE THIS DOCUMENT HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE 5-YEAR REVIEW POLICY. NOTICE THIS DOCUMENT HAS BEEN TAKEN DIRECTLY FROM U.S. MILITARY SPECIFICATION MIL-C-39029/36A, AMENDMENT 1, NOTICE 1 AND CONTAINS ONLY MINOR EDITORIAL AND FORMAT CHANGES REQUIR
6、ED TO BRING IT INTO CONFORMANCE WITH THE PUBLISHING REQUIREMENTS OF SAE TECHNICAL STANDARDS. THE INITIAL RELEASE OF THIS DOCUMENT IS INTENDED TO REPLACE MIL-C-39029/36A, AMENDMENT 1, NOTICE 1. ANY PART NUMBERS ESTABLISHED BY THE ORIGINAL SPECIFICATION REMAIN UNCHANGED. THE ORIGINAL MILITARY SPECIFIC
7、ATION WAS ADOPTED AS AN SAE STANDARD UNDER THE PROVISIONS OF THE SAE TECHNICAL STANDARDS BOARD (TSB) RULES AND REGULATIONS (TSB 001) PERTAINING TO ACCELERATED ADOPTION OF GOVERNMENT SPECIFICATIONS AND STANDARDS. TSB RULES PROVIDE FOR (A) THE PUBLICATION OF PORTIONS OF UNREVISED GOVERNMENT SPECIFICAT
8、IONS AND STANDARDS WITHOUT CONSENSUS VOTING AT THE SAE COMMITTEE LEVEL, AND (B) THE USE OF THE EXISTING GOVERNMENT SPECIFICATION OR STANDARD FORMAT. UNDER DEPARTMENT OF DEFENSE POLICIES AND PROCEDURES, ANY QUALIFICATION REQUIREMENTS AND ASSOCIATED QUALIFIED PRODUCTS LISTS ARE MANDATORY FOR DOD CONTR
9、ACTS. ANY REQUIREMENT RELATING TO QUALIFIED PRODUCTS LISTS (QPLS) HAS NOT BEEN ADOPTED BY SAE AND IS NOT PART OF THIS SAE TECHNICAL DOCUMENT. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:43:46 MSTNo reproductio
10、n or networking permitted without license from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-28748/9 CONNECTORS) AEROSPACE STANDARD AS39029/36 SHEET 2 OF 3 AS39029/36 THE COMPLETE REQUIREMENTS FOR PROCURING THE CONTACTS DESCRIBED HEREIN SHALL CONSIST OF THIS DOCUMENT AND
11、THE LATEST ISSUE OF SPECIFICATION MIL-C-39029. FIGURE 1. DIMENSIONS AND CONFIGURATION. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:43:46 MSTNo reproduction or networking permitted without license from IHS -,-,
12、- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-28748/9 CONNECTORS) AEROSPACE STANDARD AS39029/36 SHEET 3 OF 3 AS39029/36 TABLE II. DESIGN CHARACTERISTICS. TABLE III. TOOLS. REQUIREMENTS: Dimensions, design characteristics, and configuration: See FIGURE 1 and TABLES I and II. Tools
13、: See TABLE III. Vibration: Method 2005 of MIL-STD-1344, test condition II. Shock (specified pulse): Method 2004 of MIL-STD-1344, test condition I. Mating contact: MIL-C-39029/37. QPL evaluating activity: Defense Electronics Supply Center (DESC-E), Dayton, Ohio 45444. Military part number: See TABLE IV. TABLE IV. MILITARY PART NUMBER. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:43:46 MSTNo reproduction or networking permitted without license from IHS -,-,-