《SAE-AS-5197B-2003-R2007.pdf》由会员分享，可在线阅读，更多相关《SAE-AS-5197B-2003-R2007.pdf（3页珍藏版）》请在三一文库上搜索。
1、SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefr
2、om, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. SHEET 1 OF 3 AS5197 REV. B THIRD ANGLE PROJECTION AEROSPACE STANDARD AS5197 REV. B IS
3、SUED 1999-04 REVISED 2003-08 REAFFIRMED 2007-07 FITTING, TEE, FLARED TO PIPE ON SIDE CUSTODIAN: SAE G-3/G-3BPROCUREMENT SPECIFICATION: /4/ AS4842/1 FEDERAL SUPPLY CLASS 4730 FIGURE 1 - FITTING, TEE INACTIVE IN PART - SEE NOTE /17/ TABLE 1 - DIMENSIONS BASIC NO. AS5197 /16/ SIZE CODE (NOMINAL TUBE SI
4、ZE) PORT #1 REQUIREMENTS PER ASME B46.1. UNLESS OTHERWISE SPECIFIED, MACHINED SURFACES TO BE 125 in Ra. FORGED SURFACES MAY BE 250 in Ra. 13.BREAK EDGES .003 TO .015 UNLESS OTHERWISE SPECIFIED. 14.DIMENSIONING AND TOLERANCING: ASME Y14.5M-1994. 15.DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TO
5、LERANCES: LINEAR DIMENSIONS .023, ANGULAR DIMENSIONS 030. /16/EXAMPLE OF PART NUMBER: /17/PART NUMBERS WITH D MATERIAL CODE ARE INACTIVE FOR NEW DESIGN AS OF 2001-01. USE PART NUMBERS WITH W MATERIAL CODE LETTER FOR NEW DESIGN. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 20:16:52 MSTNo reproduction or networking permitted without license from IHS -,-,-