《SAE-AS-95-1995-R2007.pdf》由会员分享，可在线阅读，更多相关《SAE-AS-95-1995-R2007.pdf（4页珍藏版）》请在三一文库上搜索。
1、SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefr
2、om, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. SHEET 1 OF 4 AS95 THIRD ANGLE PROJECTION AEROSPACE STANDARD AS95 ISSUED 1995-03 REAFF
3、IRMED 2007-08 FITTING ASSEMBLY, CROSS, REDUCER AND NONREDUCER, INTERNAL FLARE ON ONE END, TO FLARED TUBE CUSTODIAN: SAE G-3/G-3BPROCUREMENT SPECIFICATION: /4/ MIL-F-5509 FEDERAL SUPPLY CLASS 4730 RATIONALE THIS DOCUMENT HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE 5-YEAR REVIEW POLICY. Copyright 2007
4、SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel:
5、877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 21:13:01 MSTNo r
6、eproduction or networking permitted without license from IHS -,-,- FITTING ASSEMBLY, CROSS, REDUCER AND NONREDUCER, INTERNAL FLARE ON ONE END, TO FLARED TUBE AEROSPACE STANDARD AS95 SHEET 2 OF 4 AS95 Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/591397
7、7001 Not for Resale, 12/04/2007 21:13:01 MSTNo reproduction or networking permitted without license from IHS -,-,- FITTING ASSEMBLY, CROSS, REDUCER AND NONREDUCER, INTERNAL FLARE ON ONE END, TO FLARED TUBE AEROSPACE STANDARD AS95 SHEET 3 OF 4 AS95 Copyright SAE International Provided by IHS under li
8、cense with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 21:13:01 MSTNo reproduction or networking permitted without license from IHS -,-,- FITTING ASSEMBLY, CROSS, REDUCER AND NONREDUCER, INTERNAL FLARE ON ONE END, TO FLARED TUBE AEROSPACE STANDARD AS95 SHEET 4 OF 4 AS95 Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 21:13:01 MSTNo reproduction or networking permitted without license from IHS -,-,-