《中英文电池充电器测试报告.docx》由会员分享，可在线阅读，更多相关《中英文电池充电器测试报告.docx（5页珍藏版）》请在三一文库上搜索。
1、电池/充电器测试分析报告BATTERY/CHARGER PROFILE REPORT R&D/0422-1 检测号： Test Request #提交日期 Date Submitted 型号 Model# 电池零件号 Batteries Part# 充电器零件号Charger Part#序列号 Serial# 电池类型 Batteries Type 充电器类型Charger Type 检测组件Component Being Tested 电池电流 Batteries Amps 充电器电流Charger Amps 充电器样式Charger Style 描述Description 检测员Test
2、Operator 热电偶位置Thermal Couple Location室温Ambient Temperature检测站Station提供手册？ Manual Provided?阅览手册？ Manual Reviewed?报告日期Report Date第三方实验室测试?Tested by a 3rd party lab? 引用电池组Reference Batteries Set如果是，请说明依照标准If so, to what standard?附件Attachment保护装置Protection Device漏电流不得超过0.1毫安。Leakage current should not e
3、xceed 0.1mA.认证类型Type of Certifications测试结果TEST RESULTS最大电压Max Voltage充电周期Charge Cycle浮动电压Float Voltage充电周期Charge Cycle最大电流Max Current充电周期Charge Cycle浮动电流Float Current充电周期Charge Cycle最大外壳温度Max Case Temp室温应小于：塑料35K+ ，金属25K+Should be less than: 35K+ Ambient for plastic; 25K+Amebient for metal充电周期Charge
4、 Cycle充电至80%容量 80% Capacity Reached评论Comments显示结果Indications检测技术员Test Technician日期Date审阅人Reviewer日期Date电池/充电器参考资料（容量，C/5等级，等等） REFERENCE BATTIERY/CHARGER INFORMATION (CAPACITY, C/5 RATING, etc.)样品编号NUMBER OF SAMPLES使用装置DEVICE TO BE USED IN电池是否标明生产厂家？IS THE BATTERY MARKED WITH THE MANUFACTURER?电池是否标明
5、类型（AGM,胶体）？IS THE BATTERY MARKED WITH THE TYPE(AGM,GEL)?电池是否标明额定电压？IS THE BATTERY MARKED WITH THE NOMINAL VOLTAGE?电池是否标明额定容量（C20和C5）？IS THE BATTERY MARKED WITH THE RATED CAPACITIES (C20 AND C5)?电池是否标明生产日期？(IS THE BATTERY MARKED WITH THE DATE OF MANUFACTURE?)电池相邻端子是否标明极性？IS THE BATTERY MARKED WITH TH
6、E POLARITY MARKINGS ADJACENT TO EACH TERMINAL?参考文献(References)1.RESNA 71762.IEC 60335-13.IEC 60335-2-294.IEC 60601-15.IEC 529合格/不合格Pass/Fail分析清单PROFILING CHECKLIST如果充电器反极性连接，不应有大于100毫安的电流流动，也不会损坏充电器。（依照ANSI/RESNA7176第14章9.2.5）IF THE CHARGER IS CONNECTED IN REVERSE POLARITY NO MORE THAN 100mAOF CURRE
7、NT SHOULD FLOW, NOR SHOULD ANY DAMAGE OCCUR. (AS PERANSI/RESNA 7176 SECTION 14 CLAUSE 9.2.5)在电流不足或超负荷情况下，充电器不会受到损坏，过电流也不会流动。CHARGER SHOULD NOT BE DAMAGED AND EXCESSIVE CURRENT SHOULD NOT FLOW DURING SHORT AND OVERLOAD CONDITIONS.尚未安装或准备安装在轮椅上的电池充电器应当符合IEC60335-29的要求，还应达到IEC529-IPX1的防潮要求（防滴）。BATTERY
8、CHARGERS THAT ARE NOT MOUNTED ON THE WHEELCHAIR AND THAT ARE INTENDED FOR WHEELCHAIR BATTERIES SHALL MEET THE REQUIREMENTS OF CLASS 2 OF IEC 60335-2-29 AND SHALL BE MOISTURE RESISTANT TO IEC 529-IPX1 (DRIP PROOF).踏板型充电器在与电池组连接后，应有不小于0.5秒的延时，之后才能通电。（依照ANSI/RESNA7176第14章9.2.7）OFF-BOARD CHARGERS SHOULD
9、 HAVE A DELAY OF NO LESS THAN 0.5s BETWEEN THE CONNECTION OF THE CHARGER TO THE BATTERY SET AND THE FLOW OF CURRENT. (AS PER ANSI/RESNA 7176 SECTION 14 CLAUSE 9.2.7)充电器连接是否标注正确？DOES CHARGER INDICATE CORRECT CONNECTION?电池充电器应当符合IEC60335-1的要求。BATTERY CHARGERS SHALL MEET THE REQUIREMENTS OF IEC 60335-1
10、 FOR CLASS II APPLIANCES.充电器经测试，应当符合40dBA/M的电磁兼容要求，应包含报告复印件。（依照ISO7176-21）CHARGER SHOULD BE TESTED TO COMPLY WITH EMC REQUIREMENTS OF40dBNm. A COPY OF THE REPORT SHOULD BE INCLUDED. (AS PER ISO 7176-21)如果充电器为车载型充电器，该充电器应当定级为IPX4.IF CHARGER IS ON-BOARD, IT SHOULD BE RATED TO IPX4.外壳表面漏电流应当低于0.1毫安，因为充
11、电器是作为医疗装置与移动设备连接的。（如电动轮椅，小型摩托车等）（依照IEC60601-1第19章第3节IV表）ENCLOSURE SURFACE LEAKAGE RESULTS SHOULD BE BELOW O.lmA BECAUSECHARGERS ARE CONSIDERED MEDICAL DEVICES WHEN USED INCONJUNCTION WITH A MOBILITY DEVICE (i.e. Powerchair, Scooter, etc.). (AS PER IEC60601-1 CLAUSE 19.3 TABLE IV)踏板型充电器是否标注出电池组的额定容量会
12、改变？（依照IEC 60335-2-29第19章第13节）DOES OFF-BOARD CHARGER INDICATE RATED CAPACITY OF THE BATTERY SETIT IS INTENDED FOR CHARGING? (AS PER IEC 60335-2-29 CLAUSE 19.13)被测充电器在为电池组不超过8小时时，电池组的电量不得少于额定容量的80%。（依照ANSI/RESNA7176第14章9.2.6）THE CHARGER SHOULD BE CAPABLE OF CHARGING THE BATTERY SET IT IS RATED FOR TO
13、80 PERCENT CAPACITY IN NO MORE THAN 8 HOURS. (AS PER ANSIIRESNA 7176 SECTION 14 CLAUSE 9.2.6)在使用过程中，踏板型充电器外壳温度不应超过一定温度，。塑料外壳不应超过60摄氏度，金属外壳不应超过50摄氏度。（依照IEC 60335-2-29第11章第8节）OFF-BOARD CHARGER CASE TEMPERATURES SHOULD NOT EXCEED 60C, IF MADE OF PLASTIC, OR 50C, IF MADE OF METAL, DURING USE. (AS PER IE
14、C 60335-2-29 CLAUSE 11.8)充电器应符合ANSI/RESNA7176第14章的要求。CHARGER NEEDS TO COMPLY WITH ANSIIRESNA 7176-14 REQUIREMENTS列出电压/电流等级。LIST VOLTAGE/AMPERAGE RATINGSlatest agricultural transformation of scientific research achievements in Dongping. Upgrading waste management, and increase the eye in the sky proj
15、ect social governance projects, promoting health care, environmental protection, peoples livelihood, such as the transformation and application of scientific and technological achievements of energy saving, give full play to science and technology in the leading role of digital construction of Dongp
16、ing, raise the level of social governance and human security. Second, raise the level of scientific talent and intelligence to play a supporting role 1, effectively enhance the peoples sense of urgency and responsibility. Current human resources has become the most important strategic resources, tal
17、ent has become a focus of competition between regions, and become the key factor to speed up development of a region. Who has the talent who will have competition. Who can put talent advantage into for technology advantage, and industry advantage, who on can won competition of initiative, XI General Secretary to United States access, with mission personnel list essential of is Ma, MA no in laboratory do research, a electric business mode, a Alibaba paid treasure, on for General Youth