《【BS标准word原稿】BS EN 12101-3-2002 Smoke and heat control systems — Part 3 Specification for powered smoke and heat exhaust ventilators.doc》由会员分享，可在线阅读，更多相关《【BS标准word原稿】BS EN 12101-3-2002 Smoke and heat control systems — Part 3 Specification for powered smoke and heat exhaust ventilators.doc（51页珍藏版）》请在三一文库上搜索。
1、豆丁网：http:/ STANDARD BS EN12101-3:2002Smoke and heat control systems Part 3: Specification for powered smoke and heat exhaust ventilatorsThe European Standard EN 12101-3:2001 has the status of aBritish StandardICS 13.220.20; 23.120NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW
2、BS EN 12101-3:2002National forewordThis British Standard is the official English language version of EN 12101-3:2002.EN 12101-3:2002 is a candidate “harmonized” European Standard and fully takes into account the requirements of the European Commission mandate M109, Fire alarm/detection, fixed firefi
3、ghting, fire and smoke control and explosion suppression products, given under the EU Construction Products Directive (89/106/EEC), and intended to lead to CE marking. The date of applicability of EN 12101-3:2002 as a “harmonized” European Standard, i.e. the date after which this standard may be use
4、d for CE marking purposes, is subject to an announcement in the Official Journal of the European Communities.EN 12101-3:2002 is the subject of transitional arrangements agreed under the European Commission mandate. The Member States have agreed a nominal transition period for the co-existence of EN
5、12101-3:2002 and their corresponding a national standard(s). It is intended that this period will comprise a nominal nine month period during which any required changes to national regulations are to be made, followed by a further nominal twelve month period for the implementation of CE marking. At
6、the end of this co-existence period, the national standard(s) will be withdrawn. In the UK, the corresponding national standard is: BS 7346-2:1990, Components for smoke and heat control systems Part 2: Specification for powered smoke and heat ventilators;and based on this nominal transition period o
7、f at least twenty-one months, subject to review, BS 7346-2;1990 would be withdrawn in April 2003 at the earliest.NOTE This date is approximate. Users of this standard should contact BSI Customer Services for confirmation of withdrawalThe UK participation in its preparation was entrusted to Technical
8、 Committee FSH/25, Smoke and heat control systems, which has the responsibility to:aid enquirers to understand the text;This British Standard, having been prepared under the direction of the Health and Environment Sector Policy and Strategy Committee, was published under the authority of the Standar
9、ds Policy and Strategy Committee on31 May 2002 BSI 31 May 2002ISBN 0 580 38228 1present to the responsible European committee any enquiries on the interpretation, or proposals for change, and keep the UK interests informed;monitor related international and European developments and promulgate them i
10、n the UK.A list of organizations represented on this committee can be obtained on request to its secretary.Cross-referencesThe British Standards which implement international or European publications referred to in this document may be found in the BSI Catalogue under the section entitled “Internati
11、onal Standards Correspondence Index”, or by using the “Search” facility of the BSI Electronic Catalogue or of British Standards Online.This publication does not purport to include all the necessary provisions of a contract. Users of this publication are responsible for their correct applicationCompl
12、iance with a British Standard does not of itself confer immunity from legal obligations.Summary of pagesThis document comprises a front cover, an inside front cover, the EN title page, pages 2 to 42, an inside back cover and a back cover.The BSI copyright date displayed in this document indicates wh
13、en the document was last issued.Amd. No.DateCommentsAmendments issued since publicationEUROPEAN STANDARD NORME EUROPENNEEUROPISCHE NORMEN 12101-3February 2002ICS 13.220.20; 23.120English versionSmoke and heat control systems - Part 3: Specification for powered smoke and heat exhaust ventilatorsSystm
14、es pour le contrle des fumes et de la chaleur - Partie 3: Spcifications pour les ventilateurs extracteurs de fumes et de chaleurRauch- und Wrmefreihaltung - Teil 3: Bestimmungen fr maschinelle Rauch- und WrmeabzugsgerteThis European Standard was approved by CEN on 9 June 2001.CEN members are bound t
15、o comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Manag
16、ement Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the of
17、ficial versions.CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIO
18、N C O M I T EUR O P EN DE NOR M A L I S A TI ON EUR O P I S C H ES KOM I TEE F R NOR M U NG Management Centre: rue de Stassart, 36 B-1050 Brussels 2002 CENAll rights of exploitation in any form and by any means reserved worldwide for CEN national Members.Ref. No. EN 12101-3:2002 EEN 12101-3:2002 (E)
19、ContentspageForeword3Introduction41 Scope62 Normative references63 Terms and definitions74 Design requirements115 General testing procedures116 Performance requirements and classification127 Marking158 Evaluation of conformity15Annex A (normative) Type approval schedule for a range of ventilators17A
20、nnex B (normative) Type approval schedule for a product range of motors25Annex C (normative) Test method for performance of powered ventilators at high temperature26Annex D (normative) Test method for resistance to temperature of electric motorsfor use in powered ventilators32Annex E (normative) Tes
21、t method for operation under load36Annex ZA (informative) Clauses of this European Standard addressing essential requirements or other provisions of EU Directives38Bibliography4241ForewordThis European Standard has been prepared by Technical Committee CEN/TC 191 Fixed firefighting systems, the secre
22、tariat of which is held by BSI.This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by August 2002, and conflicting national standards shall be withdrawn at the latest by November 2003.This European Stand
23、ard has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association, and supports essential requirements of EU Directive 89/106/EEC.For relationship with EU Directive(s), see informative annex ZA, which is an integral part of this standard.This Europ
24、ean Standard is one of six parts of the European Standard prEN 12101 covering smoke and heat control systems.This European Standard has the general title Smoke and heat control systems and consists of the following six parts:Part 1: Specification for smoke barriers Requirements and test methodsPart
25、2: Specification for natural smoke and heat exhaust ventilatorsPart 3: Specification for powered smoke and heat exhaust ventilatorsPart 4: Natural smoke and heat exhaust ventilation systems Installation and test methodsPart 5: Design and calculation for smoke and exhaust ventilation systems (publish
26、ed as CR 12101-5)Part 6: Design and calculation methods and installation procedure for pressure differential smoke control systemsprEN 12101 is included in a series of European Standards planned to cover also:- Gas extinguishing systems (EN 12094 and ISO 14520-1)- Sprinkler systems (EN 12259)- Powde
27、r systems (EN 12416)- Explosion protection systems (EN 26184)- Foam systems (EN 13565)- Hose systems (EN 671)- Water spray systemsThe annexes A to E are normative.According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement
28、 this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom.IntroductionSmoke and heat exhaust ventilation systems create a smoke fre
29、e layer above the floor by removing smoke and thus improve the conditions for the safe escape and/or rescue of people and animals and the protection of property and permit the fire to be fought while still in its early stages. They also exhaust hot gases released by a fire in the developing stage.Th
30、e use of smoke and heat exhaust ventilation systems to create smoke free areas beneath a buoyant smoke layer has become widespread. Their value in assisting in the evacuation of people from construction works, reducing fire damage and financial loss by preventing smoke logging, facilitating fire fig
31、hting, reducing roof temperatures and retarding the lateral spreadof fire is firmly established. For these benefits to be obtained it is essential that smoke and heat exhaust ventilators operate fully and reliably whenever called upon to do so during their installed life. A heat and smoke exhaust ve
32、ntilation system is a scheme of safety equipment intended to perform a positive role in a fire emergency.Components for smoke and heat exhaust systems should be installed as part of a properly designed smoke and heat system.Smoke and heat exhaust ventilation systems help to keep the escape and acces
33、s routes free from smoke; facilitate fire fighting operations by creating a smoke free layer; delay and/or prevent flashover and thus full development of the fire; protect equipment and furnishings; reduce thermal effects on structural components during a fire; reduce damage caused by thermal decomp
34、osition products and hot gases.Depending on the design of the system and the ventilator, powered or natural smoke and heat ventilators can be used in a smoke and heat control system. Powered smoke and heat exhaust ventilators can be installed in the roof or upper part of walls of building or in a du
35、cted system with the ventilator inside or outside the smoke reservoir or in a plant room.Powered smoke and heat exhaust ventilation systems should operate based on powered ventilators. The performance of the powered smoke and heat exhaust system depends on the temperature of the smoke; size, number
36、and location of the exhaust openings; the wind influence; size, geometry and location of the inlet air openings; the time of actuation; the location and conditions of the system (for example arrangements and dimensions of the building).Smoke and heat exhaust ventilation systems are used in buildings
37、 or construction works where the particular (large) dimensions, shape or configuration make smoke control necessary.Typical examples are: single and multi-storey shopping malls; single and multi-storey industrial buildings and warehouses; atria and complex buildings; enclosed car parks; stairways; t
38、unnels; theatres.Depending on differing circumstances and the situation of the building or construction works that can affect their performance, powered or natural smoke and heat exhaust ventilation systems may be used.It is specified in parts 4 and 5 of this European Standard that powered and natur
39、al exhaust ventilators should not be used to extract smoke and hot gases from the same smoke reservoir.Special conditions apply where gas extinguishing systems (e.g. according to prEN 12094 orISO 14520-1) are used (see parts 4 and 5).1 ScopeThis European standard specifies requirements and gives met
40、hods for testing powered smoke and heat exhaust ventilators that are intended to be installed as part of a powered smoke and heat exhaust ventilation system. It also provides a procedure for approving a range ofpowered smoke and heat exhaust ventilators and their motors, from a limited number of tes
41、ts.2 Normative referencesThis European Standard incorporates, by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate place in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revi
42、sions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments).EN 1363, Fire resistance tests.EN 1366, Fire resistance tests for service
43、installations.EN 60034-1, Rotating electrical machines, rating and performance.IEC 34-2, Methods for determining losses and efficiencies from test.ISO 834-1, Fire resistance tests. Elements of building construction - Part 1: General requirements for fire resistance testing.EN ISO 5167, Measurement o
44、f fluid flow by means of pressure differential devices.ISO 5221, Air distribution and air diffusion. Rules for methods of measuring air flowrate in an air handling duct.ISO 5801, Industrial fans, performance testing using standardized airways.prEN 12101-2:1995, Smoke and heat control systems - Part
45、2: Specification for natural smoke and heat exhaust ventilators.3 Terms and definitionsFor the purposes of this European Standard, the following terms and definitions apply:3.1smoke and heat control systemarrangement of components installed in a construction work to limit the effects of smoke and he
46、at from a fire3.2smoke and heat exhaust systemsmoke control system that exhausts smoke and heat from a fire in a construction work or part of a construction work3.3smoke and heat exhaust ventilation system (SHEVS)smoke and heat exhaust ventilation system consists of components jointly selected to exhaust smoke and heat to establish a buoyant layer of warm gases above cooler, cleaner air3.4natural ventilationventilation caus