《08-30189644-DC.pdf》由会员分享，可在线阅读，更多相关《08-30189644-DC.pdf（13页珍藏版）》请在三一文库上搜索。
1、a Date: 16 September 2008 Origin: International Latest date for receipt of comments: 31 December 2008 Project no.: 2008/02945 Responsible committee: AW/307 Oil seeds, animal and vegetable fats and oils and their by products Interested committees: Title: Draft BS ISO 28198 Animal and vegetable fats a
2、nd oils Determination of toluene insoluble matter Supersession information: If this document is published as a standard, the UK implementation of it will supersede NONE and partially supersede. NONE If you are aware of a current national standard which may be affected, please notify the secretary (c
3、ontact details below). WARNING: THIS IS A DRAFT AND MUST NOT BE REGARDED OR USED AS A BRITISH STANDARD. THIS DRAFT IS NOT CURRENT BEYOND 31 December 2008. This draft is issued to allow comments from interested parties; all comments will be given consideration prior to publication. No acknowledgement
4、 will normally be sent. See overleaf for information on commenting. No copying is allowed, in any form, without prior written permission from BSI except as permitted under the Copyright, Designs and Patent Act 1988 or for circulation within a nominating organization for briefing purposes. Electronic
5、 circulation is limited to dissemination by e-mail within such an organization by committee members. Further copies of this draft may be purchased from BSI Customer Services, Tel: +44(0) 20 8996 9001 or email . British, International and foreign standards are also available from BSI Customer Service
6、s. Information on the co-operating organizations represented on the committees referenced above may be obtained from the responsible committee secretary. Cross-references The British Standards which implement International or European publications referred to in this draft may be found via the Briti
7、sh Standards Online Service on the BSI web site http:/. Direct tel: 0207 283 5511 Responsible Committee Secretary: Mr John Hancock (BSI) E-mail: john.hancockfosfa.org Draft for Public Comment Head Office 389 Chiswick High Road London W4 4AL Telephone: +44(0)20 8996 9000 Fax: +44(0)20 8996 7001 Form
8、36 Version 8.0 DPC: 08/30189644 DC Licensed CopyChinese University of Hong Kong, 21/10/2008 08:42, Uncontrolled Copy, (c) BSI b Introduction This draft standard is based on international discussions in which the UK has taken an active part. Your comments on this draft are invited and will assist in
9、the preparation of the consequent standard. Comments submitted will be reviewed by the relevant BSI committee before sending the consensus UK vote and comments to the international secretariat, which will then decide appropriate action on the draft and the comments received. If no comments are recei
10、ved to the contrary, then the UK will approve this draft. If the international standard is approved, it is possible the text will be published as an identical British Standard. UK Vote Please indicate whether you consider the UK should submit a negative (with reasons) or positive vote on this draft.
11、 Submission The guidance given below is intended to ensure that all comments receive efficient and appropriate attention by the responsible BSI committee. Annotated drafts are not acceptable and will be rejected. All comments must be submitted, preferably electronically, to the Responsible Committee
12、 Secretary at the address given on the front cover. Comments should be compatible with Version 6.0 or Version 97 of Microsoft Word for Windows, if possible; otherwise comments in ASCII text format are acceptable. Any comments not submitted electronically should still adhere to these format requireme
13、nts. All comments submitted should be presented as given in the example below. Further information on submitting comments and how to obtain a blank electronic version of a comment form are available from the BSI web site at: http:/ Template for comments and secretariat observations Date: xx/xx/200x
14、Document: ISO/DIS xxxxx 1 2 (3) 4 5 (6) (7) MB Clause No./ Subclause No./ Annex (e.g. 3.1) Paragraph/ Figure/Table/ Note (e.g. Table 1) Type of com- ment Comment (justification for change) by the MB Proposed change by the MB Secretariat observations on each comment submitted 3.1 Definition 1 ed Defi
15、nition is ambiguous and needs clarifying. Amend to read . so that the mains connector to which no connection . 6.4 Paragraph 2 te The use of the UV photometer as an alternative cannot be supported as serious problems have been encountered in its use in the UK. Delete reference to UV photometer. Micr
16、osoft and MS-DOS are registered trademarks, and Windows is a trademark of Microsoft Corporation. Licensed CopyChinese University of Hong Kong, 21/10/2008 08:42, Uncontrolled Copy, (c) BSI THIS DOCUMENT IS A DRAFT CIRCULATED FOR COMMENT AND APPROVAL. IT IS THEREFORE SUBJECT TO CHANGE AND MAY NOT BE R
17、EFERRED TO AS AN INTERNATIONAL STANDARD UNTIL PUBLISHED AS SUCH. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNOLOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STANDARDS TO
18、 WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS. RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. DRAFT INTERNATIONAL STANDARD ISO/DIS 28198 International Organization
19、 for Standardization, 2008 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION ISO/TC 34/SC 11 Voting begins on: 2008-09-12 Secretariat: BSI Voting terminates on: 2009-02-12 Animal and vegetable fats and oils Determination of toluene insoluble matter Corps gra
20、s dorigines animale et vgtale Dtermination des matires insolubles dans le tolune ICS 67.200.10 In accordance with the provisions of Council Resolution 15/1993 this document is circulated in the English language only. Conformment aux dispositions de la Rsolution du Conseil 15/1993, ce document est di
21、stribu en version anglaise seulement. To expedite distribution, this document is circulated as received from the committee secretariat. ISO Central Secretariat work of editing and text composition will be undertaken at publication stage. Pour acclrer la distribution, le prsent document est distribu
22、tel quil est parvenu du secrtariat du comit. Le travail de rdaction et de composition de texte sera effectu au Secrtariat central de lISO au stade de publication. Licensed CopyChinese University of Hong Kong, 21/10/2008 08:42, Uncontrolled Copy, (c) BSI ISO/DIS 28198 ii ISO 2008 All rights reserved
23、PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file,
24、parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relat
25、ive to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. Copyri
26、ght notice This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted under the applicable laws of the users country, neither this ISO draft nor any extract from it may be reproduced, stored in a retrieval system or transmitted in any form or by any me
27、ans, electronic, photocopying, recording or otherwise, without prior written permission being secured. Requests for permission to reproduce should be addressed to either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva
28、20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Reproduction may be subject to royalty payments or a licensing agreement. Violators may be prosecuted. Licensed CopyChinese University of Hong Kong, 21/10/2008 08:42, Uncontrolled Copy, (c) BSI ISO/DIS 28198 ISO
29、2008 All rights reserved iii Contents Page Foreword iv 1 Scope1 2 Normative references1 3 Definition1 4 Principle .1 5 Reagents 1 6 Apparatus.2 7 Sampling 2 7.1 Preparation of the test sample:2 8 Procedure.3 9 Result of the determination3 9.1 Calculation:3 9.2 Interlaboratory test3 9.3 Repeatability
30、4 9.4 Reproducibility 4 10 Test report4 Annex A (informative) Results of interlaboratory tests 5 Bibliography7 Licensed CopyChinese University of Hong Kong, 21/10/2008 08:42, Uncontrolled Copy, (c) BSI ISO/DIS 28198 iv ISO 2008 All rights reserved Foreword ISO (the International Organization for Sta
31、ndardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the righ
32、t to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International
33、Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an
34、 International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 2
35、8198 was prepared by Technical Committee ISO/TC 34, Food products, Subcommittee SC 11, Animal and vegetable fats and oils. Licensed CopyChinese University of Hong Kong, 21/10/2008 08:42, Uncontrolled Copy, (c) BSI DRAFT INTERNATIONAL STANDARD ISO/DIS 28198 ISO 2008 All rights reserved 1 Animal and v
36、egetable fats and oils Determination of toluene insoluble matter 1 Scope This international standard specifies a method for the determination of the content of toluene insoluble matter (TIM) in lecithin formulations, which indicates the presence of impurities such as protein, carbohydrate- containin
37、g extraction residues and other solid contaminants. This method is applicable to all types of vegetable lecithin. The purpose of the method is to enable the analysis of lecithin under several regulations. Lecithin (Codex International Numbering System for Food Additives (INS) No. 322) is a generally
38、 permitted additive and the determination of the TIM is part of many specifications. The purity requirement with regards to toluene insoluble content is based on the method described herein. Toluene is the replacement for benzene, which is used in older methods, but must not be used for reasons of t
39、oxicity. 2 Normative references The following referenced document is indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 4793:1980, Labo
40、ratory sintered (fritted) filters; Porosity grading, classification and designation 3 Definition For the purposes of this International Standard the following terms and definitions apply. 3.1 Toluene Insoluble Matter (TIM) Quantity of those substances that are insoluble in toluene under the conditio
41、ns of this method. The Toluene Insoluble Matter is expressed in grams per 100 grams. 4 Principle The sample is dissolved in toluene and filtered through a glass filtering crucible of defined pore size (P40). The insoluble residue is dried at (103 2) C and weighed. NOTE Glass filtering crucibles with
42、 other pore sizes give different results and shall not be used. 5 Reagents WARNING Attention is drawn to the regulations which specify the handling of hazardous substances. Technical, organizational and personal safety measures shall be followed. Licensed CopyChinese University of Hong Kong, 21/10/2
43、008 08:42, Uncontrolled Copy, (c) BSI ISO/DIS 28198 2 ISO 2008 All rights reserved Unless otherwise stated analytically pure reagents are to be used. 5.1 Toluene. 6 Apparatus 6.1 30 ml glass filtering crucible P401, pore size 16 m to 40 m. NOTE According to ISO 4793 the porosity G3 (G2) is denominat
44、ed as P40 (P100). The pore size of 16 m to 40 m is recommended by JECFA (www.fao.org/ag/agn/jecfa-additives/specs/monograph4/additive-250-m4.pdf) for the determination of TIM. IMPORTANT Cleaning procedure of the glass filtering crucibles: Fill the ultrasonic bath with an phosphate-free alkaline clea
45、ning solution2 for laboratory glassware with a concentration of 10 %. Put the glass filtering crucibles into the ultrasonic bath for 30 min. Wash the glass filtering crucibles with water, and if necessary repeat the cleaning step. Clean the glass filtering crucibles in the laboratory cleaning machin
46、e. Use each glass filtering crucible for 10 analyses only, as then the pores are blocked and can not be cleaned to a sufficient standard. 6.2 Drying oven, temperature adjustable at (103 2) C. 6.3 Desiccator with silica gel. 6.4 Glass beaker, of 150 ml capacity, tall form. 6.5 Filtering bottle. 6.6 V
47、acuum pump (for the filtration). 6.7 Analytical balance. 6.8 Measuring cylinder, of 50 ml capacity. 6.9 Glass rods of different size. 7 Sampling A representative sample should have been sent to the laboratory. It should not have been damaged or changed during transport or storage. Sampling is not pa
48、rt of the method specified in this International Standard. A recommended sampling method is given in ISO 5555 1. 7.1 Preparation of the test sample: The sample is heated to max. 60 C avoiding local overheating, and is homogenized by powerful stirring. Specific treatments of the test sample (filtrati
49、on, melting etc) shall be mentioned in the analytical report. 1 DURAN filtering crucible , porosity 2, volume 30 ml, diameter 36 mm, Cat. No. 25 851 22 (www.duran-) is an example of a suitable product available commercially. 2 Extran MA03 phosphate-free (Merck 107550) is an example of a suitable product available commercially. This information is gi