《BS-EN-ISO-9456-1997.pdf》由会员分享，可在线阅读，更多相关《BS-EN-ISO-9456-1997.pdf（10页珍藏版）》请在三一文库上搜索。
1、BRITISH STANDARD BS EN ISO 9456:1997 Incorporating Amendment No. 1 to BS 6625-2:1992 (renumbers BS as BS EN ISO 9456:1997) Optics and optical instruments Ophthalmic optics Marking of spectacle frames The European Standard EN ISO 9456:1996 has the status of a British Standard ICS 11.040.70 Licensed C
2、opy: sheffieldun sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 9456:1997 This British Standard, having been prepared under the direction of the Health Care Standards Policy Committee, was published under the authority of the Standards Boards and comes into
3、 effect on 28 February 1992 BSI 06-1999 The following BSI references relate to the work on this standard: Committee reference HCC/78 Draft for comment 88/52849 DC ISBN 0 580 20514 2 Committees responsible for this British Standard The preparation of this British Standard was entrusted by the Health
4、Care Standards Policy Committee (HCC/-) to Technical Committee HCC/78, upon which the following bodies were represented: Association for Consumer Research (ACRE) Association of British Dispensing Opticians Association of British Health-care Industries Association of Contact Lens Manufacturers Britis
5、h College of Optometrists British Contact Lens Association British Medical Association British Spectacle Frame Makers Association British Universities Committee of Contact Lens Educators College of Ophthalmologists Consumer Policy Committee of BSI Department of Health Department of Trade and Industr
6、y (National Physical Laboratory) Federation of Manufacturing Opticians Federation of Ophthalmic and Dispensing Opticians Flat Glass Manufacturers Association Optic (UK) Amendments issued since publication Amd. No.DateComments 9446April 1997 Indicated by a sideline in the margin Licensed Copy: sheffi
7、eldun sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 9456:1997 BSI 06-1999i Contents Page Committees responsibleInside front cover National forewordii Foreword2 1Scope3 2Normative references3 3Marking of spectacle frames3 Annex A (informative) Recommendatio
8、ns for the provision of further information4 Annex ZA (normative) Normative references to international publications with their corresponding European publications4 Table 1 Marking of spectacle frames3 List of referencesInside back cover Licensed Copy: sheffieldun sheffieldun, na, Wed Nov 15 12:47:3
9、1 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 9456:1997 ii BSI 06-1999 National foreword This British Standard has been prepared by Technical Committee HCC/78 and is the English language version of EN ISO 9456:1996 Optics and optical instruments Ophthalmic optics Marking of spectacle frames
10、 published by the European Committee for Standardization (CEN). It is identical with ISO 9456:1991 Optics and optical instruments Ophthalmic optics Marking of spectacle frames, published by the International Organization for Standardization (ISO). It replaces 8.1 and 8.2 of BS 6625:1985 (renumbered
11、as BS 6625-1:1985 by AMD 7052). By BS 6625-1 and this British Standard, the marking of spectacle frames is now limited to the boxed lens system (see BS 3521-2), i.e. marking by the use of the alternative, outmoded datum system has been deleted. This British Standard specifies the markings to be appl
12、ied to spectacle frames but not the method of application. Annex A, which is informative, recommends certain details that should be included in any additional documentation. NOTEAlthough ISO 7998 is listed in clause 2, no reference is made to that standard elsewhere in the text. A British Standard d
13、oes not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Cross-references International standardCorresponding British
14、Standard ISO 7998:1984BS 3521 Terms relating to ophthalmic optics and spectacle frames Part 2:1991 Glossary of terms relating to spectacle frames (Incorporated as Appendix A) ISO 8624:1991BS 3199:1992 Specification for measuring system for spectacle frames (Identical) Summary of pages This document
15、comprises a front cover, an inside front cover, pages i and ii, the EN ISO title page, pages 2 to 4, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front
16、cover. Licensed Copy: sheffieldun sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN ISO 9456 June 1996 ICS 11.040.70 Descriptors: Marking, ophthalmology, optical instruments, optics, spectacle flames, medicine, optica
17、l equipment English version Optics and optical instruments Ophthalmic optics Marking of spectacle frames (ISO 9456:1991) Optique et instruments doptique Optique ophtalmique Marquage des montures de lunettes (ISO 9456:1991) Optik und optische Instrumente Augenoptik Kennzeichnung von Brillenfassungen
18、(ISO 9456:1991) This European Standard was approved by CEN on 1996-06-01. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliogr
19、aphical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a
20、CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spa
21、in, Sweden, Switzerland and United Kingdom. CEN European Committee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1996 Copyright reserved to CEN members Ref. No. EN ISO 9456:1996 E Licensed Copy: sheffieldun
22、sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN ISO 9456:1996 BSI 06-1999 2 Foreword The text of the International Standard from ISO/TC 172, Optics and optical instruments, of the International Organization for Standardization (ISO) has been taken over as a Europea
23、n Standard by the Technical Committee CEN/TC 170, Ophthalmic optics, the secretariat of which is held by DIN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by December 1996, and conflicting nationa
24、l standards shall be withdrawn at the latest by December 1996. According to CEN/CENELEC Internal regulations, the following countries are bound to implement this European Standard: Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway,
25、Portugal, Spain, Sweden, Switzerland and the United Kingdom. NOTENormative references to International Standards are listed in Annex ZA (normative). Licensed Copy: sheffieldun sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI EN ISO 9456:1996 BSI 06-19993 1 Scope This I
26、nternational Standard specifies the information to be marked on spectacle frames and its location. Recommendations are given for the provision of further information in documentation accompanying the frames or available separately. 2 Normative references The following standards contain provisions wh
27、ich, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibilit
28、y of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 7998:1984, Optics and optical instruments Spectacle frames Vocabulary and lists of equivalent terms. ISO 8624:, Optics and optical instru
29、ments Ophthalmic optics Measuring system for spectacle frames1). 3 Marking of spectacle frames Spectacle frames shall be marked with at least the information given in Table 1 and at the locations indicated. Table 1 Marking of spectacle frames 1) To be published. MarkingLocation Manufacturers or supp
30、liers identificationNot specified Model identificationNot specified Colour identificationNot specified Horizontal boxed lens size with box symbol On the front Distance between lensesOn the front Bridge width with symbol9 5On the front Overall length of sideOn a side Material identificationaOn each c
31、omponent as appropriate NOTEAll dimensions used are given in ISO 8624. a The manufacturer and supplier shall make available a key to the abbreviations or symbols used for the material identification. Licensed Copy: sheffieldun sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (
32、c) BSI EN ISO 9456:1996 4 BSI 06-1999 Annex A (informative) Recommendations for the provision of further information It is recommended that in addition to the markings specified in clause 3, Table 1, the following information should be made available in documentation accompanying the spectacle frame
33、 or should be available separately: a) Range available (size/colours). b) Components available separately. c) Lens area, in square millimetres. d) Mass of frame for an identified frame size. e) Bridge height (dimension f shown in ISO 8624, Figure 1). f) Minimum uncut diameter of lens. Annex ZA (norm
34、ative) Normative references to international publications with their corresponding European publications This European Standard incorporates by dated or undated references, provisions from other publications. These normative references are cited at the appropriate places in the text and the publicat
35、ions are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies. Publication/Yea
36、rTitleEN/Year ISO 7998:1984Optics and optical instruments Spectacle frames Vocabulary and lists of equivalent terms EN ISO 7998:1996 ISO 8624:1994Optics and optical instruments Ophthalmic optics Measuring system for spectacle frames EN ISO 8624:1996 Licensed Copy: sheffieldun sheffieldun, na, Wed No
37、v 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 9456:1997 BSI 06-1999 List of references See national foreword. Licensed Copy: sheffieldun sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI BS EN ISO 9456:1997 BSI 389 Chiswick High Road London W4 4AL B
38、SI British Standards Institution BSI is the independent national body responsible for preparing British Standards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions British Standards are updated by amendment or revision. Use
39、rs of British Standards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this British Standard would inform the Secret
40、ary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel: 020 8996 9000. Fax: 020 8996 7400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards. Buyin
41、g standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel: 020 8996 9001. Fax: 020 8996 7001. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as
42、 British Standards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which gi
43、ve details on all its products and services. Contact the Information Centre. Tel: 020 8996 7111. Fax: 020 8996 7048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefit
44、s contact Membership Administration. Tel: 020 8996 7002. Fax: 020 8996 7001. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the internationalstandardization bodies. Except as permitted under the Copyright, Designs and Patents Act
45、 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary detail
46、s such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel: 020 8996 7070. Licensed Copy: sheffieldun sheffieldun, na, Wed Nov 15 12:47:31 GMT+00:00 2006, Uncontrolled Copy, (c) BSI