《IEEE-1379-2000-R2006.pdf》由会员分享，可在线阅读，更多相关《IEEE-1379-2000-R2006.pdf（60页珍藏版）》请在三一文库上搜索。
1、Recognized as an American National Standard (ANSI) The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2001 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 16 March 2001. Printed in the United
2、 States of America. Print: ISBN 0-7381-2639-X SH94890 PDF: ISBN 0-7381-2640-3SS94890 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher. IEEE Std 1379-2000(R2006) (Revision of IEEE Std 1379-
3、1997) IEEE Recommended Practice for Data Communications Between Remote Terminal Units and Intelligent Electronic Devices in a Substation Sponsor Substations Committee of the IEEE Power Engineering Society Reaffirmed 30 March 2006 Approved 21 September 2000 IEEE-SA Standards Board Approved 1 January
4、2001 American National Standards Institute Abstract: A uniform set of guidelines for communications and interoperations of remote terminal units (RTUs) and intelligent electronic devices (IEDs) in an electric utility substation is provided. A mechanism for adding data elements and message structures
5、 to this recommended practice is described. Keywords: IED, master station, RTU, slave, supervisory control and data acquisition (SCADA) systems Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001
6、Not for Resale, 04/21/2007 12:16:18 MDTNo reproduction or networking permitted without license from IHS -,-,- IEEE Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (IEEE-SA) Standards Board. The IEEE develops its
7、standards through a consensus develop- ment process, approved by the American National Standards Institute, which brings together volunteers representing varied viewpoints and interests to achieve the fi nal product. Volunteers are not necessarily members of the Institute and serve with- out compens
8、ation. While the IEEE administers the process and establishes rules to promote fairness in the consensus devel- opment process, the IEEE does not independently evaluate, test, or verify the accuracy of any of the information contained in its standards. Use of an IEEE Standard is wholly voluntary. Th
9、e IEEE disclaims liability for any personal injury, property or other dam- age, of any nature whatsoever, whether special, indirect, consequential, or compensatory, directly or indirectly resulting from the publication, use of, or reliance upon this, or any other IEEE Standard document. The IEEE doe
10、s not warrant or represent the accuracy or content of the material contained herein, and expressly disclaims any express or implied warranty, including any implied warranty of merchantability or fi tness for a specifi c purpose, or that the use of the material contained herein is free from patent in
11、fringement. IEEE Standards documents are supplied “ AS IS .” The existence of an IEEE Standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE Standard. Furthermore, the viewpoint expressed
12、at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. Every IEEE Standard is subjected to review at least every fi ve years for revi- sion or reaffi rmation. When a document is m
13、ore than fi ve years old and has not been reaffi rmed, it is reasonable to conclude that its contents, although still of some value, do not wholly refl ect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE Standard. In publishing an
14、d making this document available, the IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity. Nor is the IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing this, and any other IEEE Standards
15、document, should rely upon the advice of a com- petent professional in determining the exercise of reasonable care in any given circumstances. Interpretations: Occasionally questions may arise regarding the meaning of portions of standards as they relate to specifi c applications. When the need for
16、interpretations is brought to the attention of IEEE, the Institute will initiate action to prepare appropriate responses. Since IEEE Standards represent a consensus of concerned interests, it is important to ensure that any interpretation has also received the concurrence of a balance of interests.
17、For this reason, IEEE and the members of its soci- eties and Standards Coordinating Committees are not able to provide an instant response to interpretation requests except in those cases where the matter has previously received formal consideration. Comments for revision of IEEE Standards are welco
18、me from any interested party, regardless of membership affi liation with IEEE. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Comments on standards and requests for interpretations should be addressed to: Secret
19、ary, IEEE-SA Standards Board 445 Hoes Lane P.O. Box 1331 Piscataway, NJ 08855-1331 USA IEEE is the sole entity that may authorize the use of certifi cation marks, trademarks, or other designations to indicate com- pliance with the materials set forth herein. Authorization to photocopy portions of an
20、y individual standard for internal or personal use is granted by the Institute of Electrical and Electronics Engineers, Inc., provided that the appropriate fee is paid to Copyright Clearance Center. To arrange for payment of licensing fee, please contact Copyright Clearance Center, Customer Service,
21、 222 Rosewood Drive, Danvers, MA 01923 USA; (978) 750-8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Note: Attention is called to the possibility that implementation of this standard may req
22、uire use of subject mat- ter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE shall not be responsible for identifying patents for which a license may be required by an IEE
23、E standard or for conducting inquiries into the legal validity or scope of those patents that are brought to its attention. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/2
24、1/2007 12:16:18 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright 2001 IEEE. All rights reserved. iii Introduction (This introduction is not part of IEEE Std 1379-2000, IEEE Recommended Practice for Data Communications Between Remote Terminal Units and Intelligent E
25、lectronic Devices in a Substation.) This recommended practice presents a uniform set of guidelines for specifi c interdevice communication details that can permit interoperation of remote terminal units (RTUs) and intelligent electronic devices (IEDs) in an electric utility substation. The data defi
26、 nitions and message structure can be used by product developers of both RTUs and IEDs to create nonproprietary communication interfaces, and by buyers and specifi ers as a defi nition or reference document for data representation and transmission. The standard can also be used as a communication in
27、terface between RTUs and supervisory control and data acquisition (SCADA) master stations. The task force that prepared this recommended practice began with the objective of providing a forum for the providers and users of (smart) devices to discuss approaches to common data interchange. As the dia-
28、 logue progressed, members decided to survey, review, and evaluate existing communications protocols and standards for those protocols. Task force members, as a result of the studies, presentations, and discussions, decided that maximum progress toward interoperability would be made if existing defi
29、 ned protocol(s) were publicly implemented. The original trial use recommended practice was the result of that decision. This recommended practice does not establish an underlying communication standard. It instead provides a specifi c implementation of two existing communication protocols already i
30、n wide scale use in the public domain (all documentation is available for a nominal fee without proprietary restriction). This document is also a template for extensions of the concept by other groups, if desired. A mechanism for adding data ele- ments and message structures to this recommended prac
31、tice is described, recognizing the rapid progress being made with IEDs of all types in all areas of the electric utility industry. There are continuing efforts in the IEEE Power Engineering Society Committees, as well as in the IEC and CIGRE to seek further compatibility among devices through commun
32、ication standards. This is being aided by the efforts of many industry groups, consultants, and suppliers who see benefi ts in such compatibility. At the time this recommended practice was developed, Task Force 1 of Working Group C3 had the following membership: H. Lee Smith, Chair William J. Ackerm
33、an Alexander Apostolov Wayne R. Block Ken L. Cooley Ken Curtis Michael J. Dood James W. Evans Ron J. Farquharson Grant Gilcrest Ameen Hamdon Derick Hammond Dennis K. Holstein Marc Lacroix Parker McCauley Bruce Muschlitz H. Lee Smith Robert C. Sodergren John T. Tengdin Michael Thesing Jack Verson Ton
34、y Watson Andrew West David Wood Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/21/2007 12:16:18 MDTNo reproduction or networking permitted without license from IHS -,-,- iv
35、 Copyright 2001 IEEE. All rights reserved. The following members of the balloting committee voted on this standard: When the IEEE-SA Standards Board approved this standard on 21 September 2000, it had the following membership: Donald N. Heirman, Chair James T. Carlo, Vice Chair Judith Gorman, Secret
36、ary *Member Emeritus Also included is the following nonvoting IEEE-SA Standards Board liaison: Alan Cookson, NIST Representative Donald R. Volzka, TAB Representative Noelle D. Humenick IEEE Standards Project Editor Hanna E. Abdallah William J. Ackerman Stan J. Arnot Thomas M. Barnes George J. Bartok
37、 Michael J. Bio Philip C. Bolin Stuart H. Bouchey Dennis L. Carr James F. Christensen John R. Clayton Ken L. Cooley Robert Corlew Frank A. Denbrock W. Bruce Dietzman Randall L. Dotson Clifford Downs Paul R. Drum Donald G. Dunn Ahmed Elneweihi Gary R. Engmann James W. Evans Ron J. Farquharson David L
38、. Harris Dennis K. Holstein James Jung George G. Karady Richard P. Keil Hermann Koch Luther W. Kurtz David S. Lehman H. Peter Lips John D. McDonald A. S. Mehraban A. P. Sakis Meliopoulos Gary L. Michel Bruce Muschlitz Daniel E. Nordell Shashi G. Patel Carlos O. Peixoto Radhakrishna V. Rebbapragada P
39、aulo F. Ribeiro David Shafer Yitzhak G. Shertok Mark S. Simon Robert C. Sodergren Brian Sparling Peter G. Stewart Charles Sufana John T. Tengdin Duane R. Torgerson Peter S. Wong John A. Zulaski Satish K. Aggarwal Mark D. Bowman Gary R. Engmann Harold E. Epstein H. Landis Floyd Jay Forster* Howard M.
40、 Frazier Ruben D. Garzon James H. Gurney Richard J. Holleman Lowell G. Johnson Robert J. Kennelly Joseph L. Koepfi nger* Peter H. Lips L. Bruce McClung Daleep C. Mohla James W. Moore Robert F. Munzner Ronald C. Petersen Gerald H. Peterson John B. Posey Gary S. Robinson Akio Tojo Donald W. Zipse Copy
41、right The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/21/2007 12:16:18 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright 2001 IEEE. All rights reserv
42、ed. v Contents 1.Overview 1 1.1 Scope 1 1.2 Purpose. 1 1.3 Distributed network protocol (DNP3) . 2 1.4 IEC 60870-5 protocol 2 2.References 2 3.Definitions, acronyms, and abbreviations 3 3.1 Definitions 3 3.2 Acronyms and abbreviations 6 4.Description of RTU-to-IED communications needs 6 4.1 The trad
43、itional SCADA protocol. 7 4.2 Specific criteria used to select protocols for RTU/IED communication . 7 5.Recommended practice for RTU/IED communication 8 5.1 General application practice using DNP3 8 5.2 General application practice using IEC-60870-5 standards. 11 5.3 Functionality of the 101 compan
44、ion standard profile 11 5.4 Summary comparative description tables 14 6.Physical layer definition (ISO/OSI layer 1). 16 6.1 Modes of transmission. 16 6.2 Local loop 16 6.3 Recommended physical layer for DNP3 16 6.4 Recommended physical layers for IEC 60870-5-101 (1995-11). 17 7.Data link layer defin
45、ition (ISO/OSI layer 2) 17 7.1 Recommended data link layer for DNP3. 17 7.2 Recommended data link layer for IEC 60870-5-101 (1995-11) 20 7.3 DNP3 pseudo-transport layer (ISO/OSI layer 4). 20 8.Application layer definition (ISO/OSI layer 7) . 21 8.1 Recommended application layer for DNP3. 21 8.2 Reco
46、mmended application layer for IEC 60870-5-101 (1995-11) 25 9.Definitions of data elements and objects. 28 9.1 DNP3 data element/object definition. 28 9.2 IEC 60870-5 data element definition. 28 9.3 Comparative tables of defined objects and data elements. 28 Copyright The Institute of Electrical and
47、Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/21/2007 12:16:18 MDTNo reproduction or networking permitted without license from IHS -,-,- vi Copyright 2001 IEEE. All rights reserved. 10.Process for addition of data
48、 elements/objects 31 10.1 Creation 31 10.2 Role of the DNP users group. 31 Annex A (informative) Comparison of DNP3 and IEC 60870-5-101. 32 Annex B (informative) Protocol implementation 38 Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELi
49、censee=NASA Technical Standards 1/9972545001 Not for Resale, 04/21/2007 12:16:18 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright 2001 IEEE. All rights reserved. 1 IEEE Recommended Practice for Data Communications Between Remote Terminal Units and Intelligent Electronic Devices in a Subst