《ISO-16000-9-2006.pdf》由会员分享，可在线阅读，更多相关《ISO-16000-9-2006.pdf（22页珍藏版）》请在三一文库上搜索。
1、 Reference number ISO 16000-9:2006(E) ISO 2006 INTERNATIONAL STANDARD ISO 16000-9 First edition 2006-02-01 Indoor air Part 9: Determination of the emission of volatile organic compounds from building products and furnishing Emission test chamber method Air intrieur Partie 9: Dosage de lmission de co
2、mposs organiques volatils de produits de construction et dobjets dquipement Mthode de la chambre dessai dmission Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo re
3、production or networking permitted without license from IHS -,-,- ISO 16000-9:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licens
4、ed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the
5、 software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to
6、 it is found, please inform the Central Secretariat at the address given below. ISO 2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without per
7、mission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2006 All rights res
8、erved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 16000-9:2006(E) ISO 2006 All rights r
9、eserved iii Contents Page Foreword iv Introduction. vi 1 Scope 1 2 Normative references1 3 Terms and definitions .2 4 Symbols and abbreviated terms 4 5 Principle4 6 Emission test chamber system4 7 Apparatus .6 8 Test conditions 6 9 Verification of the test conditions7 10 Test specimens8 11 Emission
10、test chamber preparation.8 12 Test method8 13 Calculation of area specific emission rates and expression of results.9 14 Performance characteristics 10 15 Test report10 Annex A (normative) System for quality assurance / quality control11 Annex B (informative) Examples of area specific air flow rates
11、 in a model room13 Annex C (informative) General description of an emission test chamber 14 Bibliography15 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo reproduc
12、tion or networking permitted without license from IHS -,-,- ISO 16000-9:2006(E) iv ISO 2006 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards
13、is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take pa
14、rt in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to
15、prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility th
16、at some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 16000-9 was prepared by the European Committee for Standardization (CEN) Technical Committee CEN/TC 264, Air quality, in collaboration wi
17、th Technical Committee ISO/TC 146, Air quality, Subcommittee SC 6, Indoor air, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). ISO 16000 consists of the following parts, under the general title Indoor air: Part 1: General aspects of sampling strategy
18、 Part 2: Sampling strategy for formaldehyde Part 3: Determination of formaldehyde and other carbonyl compounds Active sampling method Part 4: Determination of formaldehyde Diffusive sampling method Part 5: Measurement strategy for volatile organic compounds (VOCs) Part 6: Determination of volatile o
19、rganic compounds in indoor and test chamber air by active sampling on Tenax TA sorbent, thermal desorption and gas chromatography using MS/FID Part 7: Sampling strategy for determination of airborne asbestos fibre concentrations Part 8: Determination of local mean ages of air in buildings for charac
20、terizing ventilation conditions Part 9: Determination of the emission of volatile organic compounds from building products and furnishing Emission test chamber method Part 10: Determination of the emission of volatile organic compounds from building products and furnishing Emission test cell method
21、Part 11: Determination of the emission of volatile organic compounds from building products and furnishing Sampling, storage of samples and preparation of test specimens The following parts are under preparation: Part 12: Sampling strategy for polycyclic aromatic hydrocarbons (PAHs), polychlorinated
22、 dibenzo-p- dioxins (PCDDs), polychlorinated dibenzo-furans )PCDFs) and polychlorinated biphenyls (PCBs) Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo reproducti
23、on or networking permitted without license from IHS -,-,- ISO 16000-9:2006(E) ISO 2006 All rights reserved v Part 13: Determination of total (gas and particle-phase) polychlorinated dioxin-like biphenyls and polychlorinated dibenzo-p-dioxins/dibenzofurans Collection on sorbent-backed filters with hi
24、gh- resolution gas chromatographic/mass spectrometric analysis Part 14: Sampling strategy for nitrogen dioxide (NO2) Part 15: Measurement of nitrogen dioxide (NO2) Part 16: Detection and enumeration of moulds Sampling of moulds by filtration Part 17: Detection and enumeration of moulds Culture-based
25、 method Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 16000-9:2006(E) vi ISO 2006 All rig
26、hts reserved Introduction The determination of volatile organic compounds (VOCs) emitted from building products using emission test chambers in conjunction with the standardised sampling, storage of samples and preparation of test specimens has objectives such as: to provide manufacturers, builders,
27、 and end users with emission data useful for the evaluation of the impact of building products on the indoor air quality; to promote the development of improved products. The method can in principle be used for most building products used indoors. Copyright International Organization for Standardiza
28、tion Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO 16000-9:2006(E) ISO 2006 All rights reserved 1 Indoor air Part 9: Determ
29、ination of the emission of volatile organic compounds from building products and furnishing Emission test chamber method 1 Scope This part of ISO 16000 specifies a general laboratory test method for determination of the area specific emission rate of volatile organic compounds (VOCs) from newly prod
30、uced building products or furnishing under defined climate conditions. The method can also, in principle, be applied to aged products. The emission data obtained can be used to calculate concentrations in a model room. This part of ISO 16000 applies to various emission test chambers used for determi
31、nation of the emission of volatile organic compounds from building products or furnishing. Sampling, transport and storage of materials to be tested, and preparation of test specimens are described in ISO 16000-11. Air sampling and analytical methods for the determination of VOCs are described in IS
32、O 16000-6 and ISO 16017-1 11. A general description of an emission test chamber is given in Annex C of this part of ISO 16000. For the determination of formaldehyde emissions from wood-based panels, refer to EN 717-1:2004 12. However, ISO 16000-9 is also applicable to wood-based panels and other bui
33、lding products, in order to determine the emission rate of formaldehyde. The measurement procedure for formaldehyde is described in ISO 16000-3 1. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition
34、cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 554:1976, Standard atmospheres for conditioning and/or testing Specifications ISO 16000-6:2004, Indoor air Part 6: Determination of volatile organic compounds in indoor and te
35、st chamber air by active sampling on Tenax TA sorbent, thermal desorption and gas chromatography using MS/FID ISO 16000-11, Indoor air Part 11: Determination of the emission of volatile organic compounds from building products and furnishing Sampling, storage of samples and preparation of test speci
36、mens Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 16000-9:2006(E) 2 ISO 2006 All rights
37、reserved 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 air change rate ratio of the volume of clean air brought into the emission test chamber per hour and the free emission test chamber volume measured in identical units 3.2 air flow rate
38、air volume entering into the emission test chamber per time 3.3 air velocity air speed over the surface of the test specimen 3.4 area specific air flow rate ratio between the supply air flow rate and the area of the test specimen 3.5 building product product produced for incorporation in a permanent
39、 manner in construction works 3.6 emission test chamber enclosure with controlled operational parameters for the determination of volatile organic compounds emitted from building products 3.7 emission test chamber concentration concentration of a specific volatile organic compound, VOCx, (or group o
40、f volatile organic compounds) measured in the emission test chamber outlet 3.8 product loading factor ratio of exposed surface area of the test specimen and the free emission test chamber volume 3.9 recovery measured mass of a target volatile organic compound in the air leaving the emission test cha
41、mber during a given time period divided by the mass of target volatile organic compound added to the emission test chamber in the same time period, expressed in percent NOTE The recovery provides information about the performance of the entire method. 3.10 sample part or piece of a building product
42、that is representative of the production 3.11 specific emission rate qm product specific rate describing the mass of a volatile organic compound emitted from a product per time at a given time from the start of the test NOTE 1 Area specific emission rate, qm,AS, is used in this part of ISO 16000. Se
43、veral other specific emission rates can be defined according to different requirements, e.g. length specific emission rate, qm,LS, volume specific emission rate, qm,VS, and unit specific emission rate, qm,US. Copyright International Organization for Standardization Provided by IHS under license with
44、 ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 02:00:32 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 16000-9:2006(E) ISO 2006 All rights reserved 3 NOTE 2 The term “area specific emission rate“ is sometimes used in parallel with the te
45、rm “emission factor“. 3.12 target volatile organic compound product specific volatile organic compound 3.13 test specimen part of the sample specially prepared for emission testing in an emission test chamber in order to simulate the emission behaviour of the material or product that is tested 3.14
46、total volatile organic compound TVOC sum of the concentrations of identified and unidentified volatile organic compounds eluting between and including n-hexane and n-hexadecane. NOTE 1 For quantification of the identified compounds, their individual response is used. The areas of the unidentified pe
47、aks are converted on molecular mass basis to concentrations using the toluene response factor 2. NOTE 2 Due to practical reasons to be taken into account for test chambers, this definition differs slightly from that defined in ISO 16000-6:2004. In ISO 16000-6, TVOC are related to the sampling medium
48、 Tenax TA1) on which the TVOC are adsorbed. 3.15 volatile organic compound VOC organic compound that is emitted from the test specimen and all those detected in the chamber outlet air NOTE 1 Due to practical reasons to be taken into account for test chambers, this definition differs from that defined in ISO 16000-6:2004. In ISO 16000-6, the definition is based on the boiling point range (50 C to 100 C) t