《SAE-AS-39029-50-2000-R2007.pdf》由会员分享，可在线阅读，更多相关《SAE-AS-39029-50-2000-R2007.pdf（3页珍藏版）》请在三一文库上搜索。
1、Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUME
2、NT ORDER:Tel: 877-606-7323 (inside USA and Canada)Tel: 724-776-4970 (outside USA) Fax: 724-776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.org SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering scie
3、nces. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirm
4、ed, revised, or cancelled. SAE invites your written comments and suggestions. SHEET 1 OF 3 AS39029/50 THIRD ANGLE PROJECTION AEROSPACE STANDARD AS39029/50 ISSUED 2000-07 REAFFIRMED 2007-01 CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE, SHIELDED (FOR MIL-C-83733 CONNECTORS) PREPARED BY SAE SUB
5、COMMITTEE AE-8C1 FEDERAL SUPPLY CLASS 5935 RATIONALE THIS DOCUMENT HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE 5-YEAR REVIEW POLICY. NOTICE THIS DOCUMENT HAS BEEN TAKEN DIRECTLY FROM U.S. MILITARY SPECIFICATION MIL-C-39029/50A, NOTICE 1, NOTICE 2 AND CONTAINS ONLY MINOR EDITORIAL AND FORMAT CHANGES R
6、EQUIRED TO BRING IT INTO CONFORMANCE WITH THE PUBLISHING REQUIREMENTS OF SAE TECHNICAL STANDARDS. THE INITIAL RELEASE OF THIS DOCUMENT IS INTENDED TO REPLACE MIL-C-39029/50A, NOTICE 1, NOTICE 2. ANY PART NUMBERS ESTABLISHED BY THE ORIGINAL SPECIFICATION REMAIN UNCHANGED. THE ORIGINAL MILITARY SPECIF
7、ICATION WAS ADOPTED AS AN SAE STANDARD UNDER THE PROVISIONS OF THE SAE TECHNICAL STANDARDS BOARD (TSB) RULES AND REGULATIONS (TSB 001) PERTAINING TO ACCELERATED ADOPTION OF GOVERNMENT SPECIFICATIONS AND STANDARDS. TSB RULES PROVIDE FOR (A) THE PUBLICATION OF PORTIONS OF UNREVISED GOVERNMENT SPECIFIC
8、ATIONS AND STANDARDS WITHOUT CONSENSUS VOTING AT THE SAE COMMITTEE LEVEL, AND (B) THE USE OF THE EXISTING GOVERNMENT SPECIFICATION OR STANDARD FORMAT. UNDER DEPARTMENT OF DEFENSE POLICIES AND PROCEDURES, ANY QUALIFICATION REQUIREMENTS AND ASSOCIATED QUALIFIED PRODUCTS LISTS ARE MANDATORY FOR DOD CON
9、TRACTS. ANY REQUIREMENT RELATING TO QUALIFIED PRODUCTS LISTS (QPLS) HAS NOT BEEN ADOPTED BY SAE AND IS NOT PART OF THIS SAE TECHNICAL DOCUMENT. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 20:47:57 MSTNo reproduct
10、ion or networking permitted without license from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE, SHIELDED (FOR MIL-C-83733 CONNECTORS) AEROSPACE STANDARD AS39029/50 SHEET 2 OF 3 AS39029/50 THE COMPLETE REQUIREMENTS FOR PROCURING THE CONTACTS DESCRIBED HEREIN SHALL CONSIST OF THIS DOC
11、UMENT AND THE LATEST ISSUE OF SPECIFICATION MIL-C-39029. FIGURE 1. CONNECTOR CONTACT. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 20:47:57 MSTNo reproduction or networking permitted without license from IHS -,-,-
12、 CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE, SHIELDED (FOR MIL-C-83733 CONNECTORS) AEROSPACE STANDARD AS39029/50 SHEET 3 OF 3 AS39029/50 TABLE I. DESIGN CHARACTERISTICS. TABLE II. TOOLS. REQUIREMENTS: Dimensions, design characteristics, and configuration: See figure and table I. Tools: See
13、 table II. Vibration: Method 2005 of MIL-STD-1344, test condition VI, letter G. Shock (specified pulse): Method 2004 of MIL-STD-1344, test condition A. Mating contact: MIL-C-39029/51. Manufacturers recommended assembly instructions to be shipped with unit package. Insulation resistance: Greater than
14、 5,000 megohms. Dielectric withstanding voltage: 500 Vac rms at sea level. QPL evaluating activity: AFALD/PTES, Wright-Patterson AFB, OH 45433. Military part number: See table III. TABLE III. MILITARY PART NUMBER. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 20:47:57 MSTNo reproduction or networking permitted without license from IHS -,-,-