《SAE-AS-39029-48-2000-R2007.pdf》由会员分享，可在线阅读，更多相关《SAE-AS-39029-48-2000-R2007.pdf（8页珍藏版）》请在三一文库上搜索。
1、Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUME
2、NT ORDER:Tel: 877-606-7323 (inside USA and Canada)Tel: 724-776-4970 (outside USA) Fax: 724-776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.org SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering scie
3、nces. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirm
4、ed, revised, or cancelled. SAE invites your written comments and suggestions. SHEET 1 OF 8 AS39029/48 THIRD ANGLE PROJECTION AEROSPACE STANDARD AS39029/48 ISSUED 2000-07 REAFFIRMED 2007-06 CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) PREPARED BY SAE SUBCO
5、MMITTEE AE-8C1 FEDERAL SUPPLY CLASS 5935 RATIONALE THIS DOCUMENT HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE 5-YEAR REVIEW POLICY. NOTICE THIS DOCUMENT HAS BEEN TAKEN DIRECTLY FROM U.S. MILITARY SPECIFICATION MIL-C-39029/48D AND CONTAINS ONLY MINOR EDITORIAL AND FORMAT CHANGES REQUIRED TO BRING IT IN
6、TO CONFORMANCE WITH THE PUBLISHING REQUIREMENTS OF SAE TECHNICAL STANDARDS. THE INITIAL RELEASE OF THIS DOCUMENT IS INTENDED TO REPLACE MIL-C-39029/48D. ANY PART NUMBERS ESTABLISHED BY THE ORIGINAL SPECIFICATION REMAIN UNCHANGED. THE ORIGINAL MILITARY SPECIFICATION WAS ADOPTED AS AN SAE STANDARD UND
7、ER THE PROVISIONS OF THE SAE TECHNICAL STANDARDS BOARD (TSB) RULES AND REGULATIONS (TSB 001) PERTAINING TO ACCELERATED ADOPTION OF GOVERNMENT SPECIFICATIONS AND STANDARDS. TSB RULES PROVIDE FOR (A) THE PUBLICATION OF PORTIONS OF UNREVISED GOVERNMENT SPECIFICATIONS AND STANDARDS WITHOUT CONSENSUS VOT
8、ING AT THE SAE COMMITTEE LEVEL, AND (B) THE USE OF THE EXISTING GOVERNMENT SPECIFICATION OR STANDARD FORMAT. UNDER DEPARTMENT OF DEFENSE POLICIES AND PROCEDURES, ANY QUALIFICATION REQUIREMENTS AND ASSOCIATED QUALIFIED PRODUCTS LISTS ARE MANDATORY FOR DOD CONTRACTS. ANY REQUIREMENT RELATING TO QUALIF
9、IED PRODUCTS LISTS (QPLS) HAS NOT BEEN ADOPTED BY SAE AND IS NOT PART OF THIS SAE TECHNICAL DOCUMENT. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:46:14 MSTNo reproduction or networking permitted without licens
10、e from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) AEROSPACE STANDARD AS39029/48 SHEET 2 OF 8 AS39029/48 THE COMPLETE REQUIREMENTS FOR ACQUIRING THE CONTACTS DESCRIBED HEREIN SHALL CONSIST OF THIS SPECIFICATION AND THE LATEST ISSUE OF MIL-C-390
11、29. FIGURE 1. DIMENSIONS AND CONFIGURATION. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:46:14 MSTNo reproduction or networking permitted without license from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIM
12、P REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) AEROSPACE STANDARD AS39029/48 SHEET 3 OF 8 AS39029/48 FIGURE 1. DIMENSIONS AND CONFIGURATION - CONTINUED. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:46:14 MSTN
13、o reproduction or networking permitted without license from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) AEROSPACE STANDARD AS39029/48 SHEET 4 OF 8 AS39029/48 FIGURE 1. DIMENSIONS AND CONFIGURATION - CONTINUED. Copyright SAE International Provid
14、ed by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:46:14 MSTNo reproduction or networking permitted without license from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) AEROSPACE STANDARD AS39029/48
15、 SHEET 5 OF 8 AS39029/48 REQUIREMENTS: Dimensions, design characteristics, and configuration: See figure 1 and tables I and II. Wire barrel: Wire barrel ranges and size shall be a specified in table IV. Tools: See table III. Vibration: In accordance with method 2005 of MIL-STD-1344, test condition I
16、II. The following detail and exceptions shall apply. a. Normal locking means only, no safety wire shall be used. b. The cable or wire bundle shall be clamped to nonvibrating points at least 8 inches from the rear of the connectors. The clamping length may be selected or changed to avoid resonance of
17、 the cable or wire. c. The system ground contacts of class L grounding connectors shall not be wired into the series monitoring circuit. Shock: MIL-C-39029/48 contacts shall be tested in accordance with the drop test (class L) and high impact shock test as specified in MIL-C-22992, using a MIL-C-229
18、92 qualified connector that has been approved for listing on the applicable qualified products list. Mating contact: MIL-C-39029/49. Material: Copper alloy SAE CA145; SAE CA147. Hard temper; CABRA 147 or equivalent. Finish: Silver plate .0002 inch thick minimum in accordance with QQ-S-365. Use under
19、plate of .00005 inch minimum nickel in accordance with QQ-N-290. Concentricity: .004 TIR(RFS), machined surfaces 63 V unless otherwise specified. Contacts may be soldered or crimped. Qualification: Shall include the crimping of these contacts utilizing MS3448 bushings to accommodate smaller wire siz
20、es. QPL evaluating activity: Defense Electronics Supply Center (DESC-E), Dayton, Ohio 45444. International interest: NEPR 57, class L only. Military part number: See table V. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/0
21、4/2007 18:46:14 MSTNo reproduction or networking permitted without license from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) AEROSPACE STANDARD AS39029/48 SHEET 6 OF 8 AS39029/48 TABLE II. DESIGN CHARACTERISTICS. Copyright SAE International Prov
22、ided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:46:14 MSTNo reproduction or networking permitted without license from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) AEROSPACE STANDARD AS39029/
23、48 SHEET 7 OF 8 AS39029/48 TABLE III. TOOLS. TABLE IV. ALLOWABLE WIRE BARREL - WIRE SIZE COMBINATIONS. Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:46:14 MSTNo reproduction or networking permitted without licen
24、se from IHS -,-,- CONTACTS, ELECTRICAL CONNECTOR, PIN, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS) AEROSPACE STANDARD AS39029/48 SHEET 8 OF 8 AS39029/48 TABLE V. MILITARY PART NUMBER Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 18:46:14 MSTNo reproduction or networking permitted without license from IHS -,-,-