《UL-107-2001.pdf》由会员分享，可在线阅读，更多相关《UL-107-2001.pdf（19页珍藏版）》请在三一文库上搜索。
1、UL 107 ISBN 0-7629-0627-8 Asbestos-Cement Pipe and Couplings Copyright Underwriters Laboratories Inc. Provided by IHS under license with ULLicensee=Army Northwestern Div./7838506130 Not for Resale, 08/29/2006 10:10:26 MDTNo reproduction or networking permitted without license from IHS -,-,- FEBRUARY
2、 9,2001 - UL 107 trl Underwriters Laboratories Inc. (UL) 333 Pfingsten Road Northbrook. IL 60062-2096 UL Standard for Safety for Asbestos-Cement Pipe and Couplings, UL 107 Fifth Edition, Dated February 9, 2001 The master for this Standard at ULs Northbrook Office is the official document insofar as
3、it relates to a UL service and the compliance of a product with respect to the requirements for that product and service, or if there are questions regarding the accuracy of this Standard. ULs Standards for Safety are copyrighted by UL. Neither a printed copy of a Standard, nor the distribution disk
4、ette for a Standard-on-Diskette and the file for the Standard on the distribution diskette should be altered in any way. All of ULs Standards and all copyrights, ownerships, and rights regarding those Standards shall remain the sole and exclusive property of UL. All rights reserved. No part of this
5、publication may be reproduced, stored in a retrieval system, or transmitted in any form by any means, electronic, mechanical photocopying, recording, or otherwise without prior permission of UL. Revisions of UL Standards for Safety are issued from time to time. A UL Standard for Safety is current on
6、ly if it incorporates the most recently adopted revisions. UL provides this Standard ”as is” without warranty of any kind, either expressed or implied, including but not limited to, the implied warranties of merchantability or fitness for any purpose. In no event will UL be liable for any special, i
7、ncidental, consequential, indirect or similar damages, including loss of profits, lost savings, loss of data, or any other damages arising out of the use of or the inability to use this Standard, even if UL or an authorized UL representative has been advised of the possibility of such damage. In no
8、event shall ULs liability for any damage ever exceed the price paid for this Standard, regardless of the form of the claim. UL will attempt to answer support requests concerning electronic versions of its Standards. However, this support service is offered on a reasonable efforts basis only, and UL
9、may not be able to resolve every support request. UL supports the electronic versions of its Standards only if they are used under the conditions and operating systems for which it is intended. ULs support policies may change from time-to-time without notification. UL reserves the right to change th
10、e format, presentation, file types and formats, delivery methods and formats, and the like of both its printed and electronic Standards without prior notice. Purchasers of the electronic versions of ULs Standards for Safety agree to defend, indemnify, and hold UL harmless from and against any loss,
11、expense, liability, damage, claim, or judgement (including reasonable attorneys fees) resulting from any error or deviation introduced while purchaser is storing an electronic Standard on the purchasers computer system. If a single-user version electronic Standard was purchased, one copy of this Sta
12、ndard may be stored on the hard disk of a single personal computer, or on a single LAN file-sewer or the permanent storage device of a multiple-user computer in such a manner that this Standard may only be accessed by one user at a time and for which there is no possibility of multiple concurrent ac
13、cess. Copyright Underwriters Laboratories Inc. Provided by IHS under license with ULLicensee=Army Northwestern Div./7838506130 Not for Resale, 08/29/2006 10:10:26 MDTNo reproduction or networking permitted without license from IHS -,-,- tr2 FEBRUARY 9,2001 - UL 107 If a multiple-user version electro
14、nic Standard was purchased, one copy of the Standard may be stored on a single LAN file-server, or on the permanent storage device of a multiple-user computer, or on an Intranet server. The number of concurrent users shall not exceed the number of users authorized. Electronic Standards are intended
15、for on-line use, such as for viewing the requirements of a Standard, conducting a word search, and the like. Only one copy of the Standard may be printed from each single-user version of an electronic Standard. Only one copy of the Standard may be printed for each authorized user of a multiple-user
16、version of an electronic Standard. Because of differences in the computer/software/printer setup used by UL and those of electronic Standards purchasers, the printed copy obtained by a purchaser may not look exactly like the on-line screen view or the printed Standard. An employee of an organization
17、 purchasing a UL Standard can make a copy of the page or pages being viewed for their own fair and/or practical internal use. The requirements in this Standard are now in effect, except for those paragraphs, sections, tables, figures, and/or other elements of the Standard having future effective dat
18、es as indicated in the note following the affected item. The prior text for requirements that have been revised and that have a future effective date are located after the Standard, and are preceded by a ”SUPERSEDED REQUIREMENTS” notice. New product submittals made prior to a specified future effect
19、ive date will be judged under all of the requirements in this Standard including those requirements with a specified future effective date, unless the applicant specifically requests that the product be judged under the current requirements. However, if the applicant elects this option, it should be
20、 noted that compliance with all the requirements in this Standard will be required as a condition of continued Listing and Follow-Up Services after the effective date, and understanding of this should be signified in writing. Copyright O 2001 Underwriters Laboratories Inc. This Standard consists of
21、pages dated as shown in the following checklist: Page Date 1-16 February 9,2001 Copyright Underwriters Laboratories Inc. Provided by IHS under license with ULLicensee=Army Northwestern Div./7838506130 Not for Resale, 08/29/2006 10:10:26 MDTNo reproduction or networking permitted without license from
22、 IHS -,-,- FEBRUARY 9,2001 1 UL 107 Standard for Asbestos-Cement Pipe and Couplings First Edition - September, 1967 Second Edition - April, 1973 Third Edition - August, 1980 Fourth Edition - March. 1993 Fifth Edition February 9,2001 An effective date included as a note immediately following certain
23、requirements is one established by Underwriters Laboratories Inc. Revisions of this Standard will be made by issuing revised or additional pages bearing their date of issue. A UL Standard is current only if it incorporates the most recently adopted revisions, all of which are itemized on the transmi
24、ttal notice that accompanies the latest set of revised requirements. ISBN 0-7629-0627-8 COPYRIGHT O 1980, 2001 UNDERWRITERS LABORATORIES INC. Copyright Underwriters Laboratories Inc. Provided by IHS under license with ULLicensee=Army Northwestern Div./7838506130 Not for Resale, 08/29/2006 10:10:26 M
25、DTNo reproduction or networking permitted without license from IHS -,-,- 2 ASBESTOS-CEMENT PIPE AND COUPLINGS - UL 107 FEBRUARY 9,2001 No Text on This Page Copyright Underwriters Laboratories Inc. Provided by IHS under license with ULLicensee=Army Northwestern Div./7838506130 Not for Resale, 08/29/2
26、006 10:10:26 MDTNo reproduction or networking permitted without license from IHS -,-,- FEBRUARY 9.2001 ASBESTOS-CEMENT PIPE AND COUPLINGS . UL 107 3 CONTENTS FOREWORD 4 INTRODUCTION 1 Scope . 5 2 Components 5 3 Units of Measurement . 6 4 Undated references . 6 5 Glossary . 6 CONSTRUCTION 6 Materials
27、 . 6 8 Pipe Ends 7 9 Straightness of Pipe . 7 10 Couplings . 7 11 Imperfections 7 12 Sealing Gaskets . 8 7 Pipe Diameters . 6 PERFORMANCE 13 General . 8 14 Elastomeric Parts Test . 8 15 Hydrostatic Strength 9 16 Flexural Strength . 1 0 17 Crushing Strength 11 18 Leakage Test for Joints 12 19 Assembl
28、y Test . 13 20 Service Connections (Corporation Stops) 13 MANUFACTURING AND PRODUCTION TESTS 21 General 14 23 Flexural Tests 15 24 Hardness Tests . 15 22 Hydrostatic Tests . 14 MARKING 25 General 15 26 Pipe . 15 27 Couplings 16 28 Rubber Gaskets 16 Copyright Underwriters Laboratories Inc. Provided b
29、y IHS under license with ULLicensee=Army Northwestern Div./7838506130 Not for Resale, 08/29/2006 10:10:26 MDTNo reproduction or networking permitted without license from IHS -,-,- 4 ASBESTOS-CEMENT PIPE AND COUPLINGS - UL 107 FEBRUARY 9,2001 FOREWORD A. This Standard contains basic requirements for
30、products covered by Underwriters Laboratories Inc. (UL) under its Follow-Up Service for this category within the limitations given below and in the Scope section of this Standard. These requirements are based upon sound engineering principles, research, records of tests and field experience, and an
31、appreciation of the problems of manufacture, installation, and use derived from consultation with and information obtained from manufacturers, users, inspection authorities, and others having specialized experience. They are subject to revision as further experience and investigation may show is nec
32、essary or desirable. B. The observance of the requirements of this Standard by a manufacturer is one of the conditions of the continued coverage of the manufacturers product. C. A product which complies with the text of this Standard will not necessarily be judged to comply with the Standard if, whe
33、n examined and tested, it is found to have other features which impair the level of safety contemplated by these requirements. D. A product employing materials or having forms of construction which conflict with specific requirements of the Standard cannot be judged to comply with the Standard. A pr
34、oduct employing materials or having forms of construction not addressed by this Standard may be examined and tested according to the intent of the requirements and, if found to meet the intent of this Standard, may be judged to comply with the Standard. E. UL, in performing its functions in accordan
35、ce with its objectives, does not assume or undertake to discharge any responsibility of the manufacturer or any other party. The opinions and findings of UL represent its professional judgment given with due consideration to the necessary limitations of practical operation and state of the art at th
36、e time the Standard is processed. UL shall not be responsible to anyone for the use of or reliance upon this Standard by anyone. UL shall not incur any obligation or liability for damages, including consequential damages, arising out of or in connection with the use, interpretation of, or reliance u
37、pon this Standard. F. Many tests required by the Standards of UL are inherently hazardous and adequate safeguards for personnel and property shall be employed in conducting such tests. Copyright Underwriters Laboratories Inc. Provided by IHS under license with ULLicensee=Army Northwestern Div./78385
38、06130 Not for Resale, 08/29/2006 10:10:26 MDTNo reproduction or networking permitted without license from IHS -,-,- FEBRUARY 9,2001 ASBESTOS-CEMENT PIPE AND COUPLINGS - UL 107 5 INTRODUCTION 1 Scope 1.1 These requirements cover asbestos-cement pressure pipe, couplings, and gaskets for use in undergr
39、ound, fire service systems and connections to such systems. The pipe consists of either the distribution or transmission type. 1.2 Requirements for the installation and use of asbestos-cement distribution pipe and couplings are included in the Standard of the National Fire Protection Association for
40、 Outside Protection, ANSVNFPA No. 24, the Standard for Installation of Private Fire Service Mains and Their Appurtenances and the Standard for the Installation of Asbestos-Cement Pressure Pipe, ANSVAWWA C603. 1.3 Requirements for the installation and use of asbestos-cement transmission pipe and coup
41、lings are included in the Standard for the Selection of Asbestos-Cement Transmission Sizes 18 in. Through 42 in. (450 mm Through 1,050 mm), for Water Supply Service, ANSVAWWA C403 and the Standard for the Installation of Asbestos-Cement Pressure Pipe, ANSVAWWA C603. 1.4 A product that contains featu
42、res, characteristics, components, materials, or systems new or different from those covered by the requirements in this standard, and that involves a risk of fire or of electric shock or injury to persons shall be evaluated using appropriate additional component and end-product requirements to maint
43、ain the level of safety as originally anticipated by the intent of this standard. A product whose features, characteristics, components, materials, or systems conflict with specific requirements or provisions of this standard does not comply with this standard. Revision of requirements shall be prop
44、osed and adopted in conformance with the methods employed for development, revision, and implementation of this standard. 2 Components 2.1 Except as indicated in 2.2, a component of a product covered by this standard shall comply with the requirements for that component. 2.2 A component is not requi
45、red to comply with a specific requirement that: a) Involves a feature or characteristic not required in the application of the component in the product covered by this standard, or b) Is superseded by a requirement in this standard. 2.3 A component shall be used in accordance with its rating establi
46、shed for the intended conditions of use. 2.4 Specific components are incomplete in construction features or restricted in performance capabilities. Such components are intended for use only under limited conditions, such as certain temperatures not exceeding specified limits, and shall be used only
47、under those specific conditions. Copyright Underwriters Laboratories Inc. Provided by IHS under license with ULLicensee=Army Northwestern Div./7838506130 Not for Resale, 08/29/2006 10:10:26 MDTNo reproduction or networking permitted without license from IHS -,-,- 6 ASBESTOS-CEMENT PIPE AND COUPLINGS
48、 - UL 107 FEBRUARY 9,2001 3 Units of Measurement 3.1 Values stated without parentheses are the requirement. Values in parentheses are explanatory or approximate information. 4 Undated references 4.1 Any undated reference to a code or standard appearing in the requirements of this standard shall be interpreted as referring to the latest edition of that code or standard. 5 Glossary 5.1 For the purposes of this Standard, the following definitions apply. 5.2 DISTRIBUTION PIPE AND COUPLINGS - Pipe having nominal inside diameters from 4 to 24 inches (102 to 610 m