《ISO-4030-1983.pdf》由会员分享，可在线阅读，更多相关《ISO-4030-1983.pdf（3页珍藏版）》请在三一文库上搜索。
1、International Standard INTERNATIONAL ORGANlZATlON FOR STANDARDIZATION.MEYHAPOIIHAR OPrAHHJAL or 4.2 When, for regulatory reasons, the VIN must be readable from the outside of the vehicle (in the case of enclosed vehicles), it shall be located inside the passenger compartment adjacent to the windscre
2、en pillar. 4.3 The VIN shall be located in an easily visible position, and in a manner which precludes obliteration or alteration; the selected position shall be described in the “Owners handbook” or equivalent publication. 5 VIN attachment For the attachment of the VIN, the manufacturer of the vehi
3、cle may choose between the following two solutions : 5.1 The VIN is directly marked) on a integral part of the vehicle; it may be either on the frame, or, for integral frame- body units, on a part of the body not easily removed or re- placed. 5.2 The VIN is marked on a separate plate which, in turn,
4、 is permanently affixed to the vehicle according to 5.1. 5.3 It is also acceptable to combine these alternatives on one vehicle if a manufacturer so wishes. 5.4 The height of roman letters and arabic numerals of the VIN shall be as follows : - 7 mm at least if marked according to 5.1 (frame, body, etc.) on motor vehicles and trailers (but not on motorcycles and mopeds); - 4 mm at least in all other cases. 5.5 The characters of the VIN shall, in all cases, be legible, durable and not easily altered. 1) The requirements for the presentation of the VIN are given in IS0 3779. 1 -,-,-