《BS EN 4604-002-2009 航空航天系列.信号传输用电缆,电器概述.pdf》由会员分享，可在线阅读，更多相关《BS EN 4604-002-2009 航空航天系列.信号传输用电缆,电器概述.pdf（10页珍藏版）》请在三一文库上搜索。
1、 EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 4604-002 September 2009 ICS 49.060 Supersedes EN 4604-002:2006 English Version Aerospace series - Cable, electrical, for signal transmission - Part 002: General Srie arospatiale - Cbles lectriques pour transmission de signaux - Partie 002: Gnrali
2、ts Luft- und Raumfahrt - Elektrische Leitungen fur Signalubertragungen - Teil 002: Allgemeines This European Standard was approved by CEN on 20 June 2009. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the st
3、atus of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German).
4、 A version in any other language made by translation under the respons bility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Repub
5、lic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE
6、NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: Avenue Marnix 17, B-1000 Brussels 2009 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 4604-002:2009: E EN 4604-002:2009 (E) 2 Contents Page Foreword 3 1 Scope 4 2 Nor
7、mative references 4 3 Terms and definitions .5 4 List of product standards .5 5 Materials and construction .5 6 Identification and marking 6 7 Technical specification .6 EN 4604-002:2009 (E) 3 Foreword This document (EN 4604-002:2009) has been prepared by the Aerospace and Defence Industries Associa
8、tion of Europe - Standardization (ASD-STAN). After enquiries and votes carried out in accordance with the rules of this Association, this Standard has received the approval of the National Associations and the Official Services of the member countries of ASD, prior to its presentation to CEN. This E
9、uropean Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by March 2010, and conflicting national standards shall be withdrawn at the latest by March 2010. Attention is drawn to the possibility that some of the elem
10、ents of this document may be the subject of patent rights. CEN and/or CENELEC shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 4604-002:2006. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the followi
11、ng countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Sloven
12、ia, Spain, Sweden, Switzerland and the United Kingdom. EN 4604-002:2009 (E) 4 1 Scope This standard specifies the list of product standards and common characteristics of signal transmission electrical cables for use in the on-board electrical systems of aircraft. 2 Normative references The following
13、 referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 3475-100, Aerospace series Cables, electrical, aircraft use
14、 Test methods Part 100: General. EN 3838, Aerospace series Requirements and tests on user-applied markings on aircraft electrical cables. 1) EN 4604-001, Aerospace series Cable, electrical, for signal transmission Part 001: Technical specification. EN 4604-003, Aerospace series Cable, electrical, fo
15、r signal transmission Part 003: Cable, coaxial 50 ohm, 200 C, type WZ Product standard. EN 4604-004, Aerospace series Cable, electrical, for signal transmission Part 004: Cable, microcoaxial, high immunity, 50 ohms, 200 C, type WS Product standard. EN 4604-005, Aerospace series Cable, electrical, fo
16、r signal transmission Part 005: Cable, coaxial, 75 ohms, 200 C, type WL Product standard. 1) EN 4604-006, Aerospace series Cable, electrical, for signal transmission Part 006: Cable, coaxial, 50 ohm, 200 C, type WM Product standard. EN 4604-007, Aerospace series Cable, electrical, for signal transmi
17、ssion Part 007: Cable, coaxial, 50 ohms, 200 C, type WN Product standard. EN 4604-008, Aerospace series Cable, electrical, for signal transmission Part 008: Cable, coaxial, 50 ohms, 200 C, type WD Product standard. EN 4604-009, Aerospace series Cable, electrical, for signal transmission Part 009: Ca
18、ble, coaxial, light weight, 50 ohms, 180 C, type KW (light WN) Product standard. EN 4604-010, Aerospace series Cable, electrical, for signal transmission Part 010: Cable, coaxial, light weight, 50 ohms, 200 C, type KX (light WD) Product standard. TR 6058, Aerospace series Cable code identification l
19、ist. 2) 1) Published as ASD Prestandard at the date of publication of this standard. 2) Published as ASD Technical Report at the date of publication of this standard. EN 4604-002:2009 (E) 5 3 Terms and definitions For the purposes of this document, the terms and definitions given in EN 3475-100 appl
20、y. 4 List of product standards See Table 1. Table 1 Product reference Main use Cable code Impedance Attenuation at 1 GHz max. Db per 100 m External diameter nominal mm Type of screening Others EN 4604-003 up to 3 GHz WZ 50 2 47 3,60 foil braid 65 C to 200 C EN 4604-004 up to 3 GHz WS 50 5 140 2,40 2
21、 braids with foil 55 C to 200 C EN 4604-005 up to 3 GHz WL 75 5 102 2,35 2 braids 55 C to 200 C EN 4604-006 up to 5 GHz WM 50 3 40 3,85 foil braid 55 C to 200 C EN 4604-007 up to 6 GHz WN 50 3 15 8,0 foil braid 55 C to 200 C EN 4604-008 up to 8 GHz WD 50 2 28,6 7,70 2 braids 55 C to 200 C EN 4604-00
22、9 up to 6 GHz light weight KW 50 3 15 7,50 foil braid 65 C to 180 C light WN full CCAL EN 4604-010 up to 6 GHz light weight KX 50 2 28,6 5,40 foil braid 65 C to 200 C light WD 5 Materials and construction The composition, dimensions and mass of the cable shall conform to the characteristics and valu
23、es defined in the technical specification and product standards. Colour coding: See product standard. EN 4604-002:2009 (E) 6 6 Identification and marking The identification and marking of cables by the manufacturer shall be in accordance with EN 4604-001. Colour of the marking: See product standard.
24、 As the designation required for orders is generally too long for use in electrical drawings, a shorter cross designation (without colour information) is given by TR 6058. EXAMPLE Designation: EN 4604-003 Cross reference WZ This shorter designation is used for identification and marking as the follo
25、wing example (see Figure 1): EN WZ DEG 00 Reference to EN-standard cable 2 mandatory spaces Type code Manufacturer country code Manufacturer code Year of manufacturing Figure 1 The cables shall be capable of being printed with the user applied markings according to EN 3838 when applicable in the product standard. 7 Technical specification See EN 4604-001. - -