《ISO-20117-2004.pdf》由会员分享，可在线阅读，更多相关《ISO-20117-2004.pdf（92页珍藏版）》请在三一文库上搜索。
1、 Reference number ISO/IEC 20117:2004(E) ISO/IEC 2004 INTERNATIONAL STANDARD ISO/IEC 20117 First edition 2004-05-15 Information technology Telecommunications and information exchange between systems Private Integrated Services Network Inter- exchange signalling protocol Message centre monitoring and
2、mailbox identification supplementary services Technologies de linformation Tlcommunications et change dinformation entre systmes Rseau priv intgration de services Protocole de signalisation dchange Services supplmentaires de surveillance du centre du message et didentification de bote aux lettres Co
3、pyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 01:28:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 20117:2004(E) PDF disclaimer This P
4、DF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therei
5、n the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the
6、PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO/IEC 2004 All rights res
7、erved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the reque
8、ster. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO/IEC 2004 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with I
9、SO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 01:28:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 20117:2004(E) ISO/IEC 2004 All rights reserved iii Contents Page Foreword.v Introduction .vi 1 Scope1 2 Conformance.1 3 Normat
10、ive references .2 4 Terms and definitions.3 4.1 External definitions.3 4.2 Other definitions .3 5 Acronyms.4 6 Signalling protocol for the support of SS-MCM.4 6.1 SS-MCM description.4 6.2 SS-MCM operational requirements .4 6.3 SS-MCM coding requirements.5 6.4 SS-MCM state definitions.13 6.5 SS-MCM s
11、ignalling procedures.13 6.6 SS-MCM impact of interworking with public ISDNs 20 6.7 SS-MCM impact of interworking with non-ISDNs21 6.8 Protocol interactions between SS-MCM and other supplementary services and ANFs .21 6.9 SS-MCM parameter values (timers).24 7 Signalling protocol for the support of SS
12、-MID.25 7.1 SS-MID description .25 7.2 SS-MID operational requirements .25 7.3 SS-MID coding requirements.26 7.4 SS-MID state definitions.28 7.5 SS-MID signalling procedures.29 7.6 SS-MID impact of interworking with public ISDNs 31 7.7 SS-MID impact of interworking with non-ISDNs31 7.8 Protocol inte
13、ractions between SS-MID and other supplementary services and ANFs .31 7.9 SS-MID parameter values (timers).34 Annex A (normative) Protocol Implementation Conformance Statement (PICS) Proforma.35 A.1 Introduction .35 A.2 Instructions for completing the PICS proforma.35 A.3 PICS proforma for SS-MCM37
14、A.4 PICS proforma for SS-MID41 Annex B (informative) Examples of Message Sequences44 B.1 Example message sequence for SS-MCM45 B.2 Example message sequences for interworking between for SS-MCM and SS-MWI53 B.3 Example message sequence for SS-MID62 Annex C (informative) Specification and Description
15、Language (SDL) Representation of Procedures 64 C.1 SDL representation of SS-MCM at the Message Centre PINX65 C.2 SDL representation of SS-MCM at the Served User PINX.72 C.3 SDL representation of SS-MID at the Message Centre PINX79 C.4 SDL representation of SS-MID at the Served User PINX.82 Copyright
16、 International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 01:28:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 20117:2004(E) iv ISO/IEC 2004 All rights r
17、eserved Annex D (informative) List of Message Types .84 D.1 Telephony Type Messages.84 D.2 Data Type Messages.84 D.3 Combination of Messages85 D.4 Additional Message Types .85 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/11111
18、11001, User=Wing, Bernie Not for Resale, 04/04/2007 01:28:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 20117:2004(E) ISO/IEC 2004 All rights reserved v Foreword ISO (the International Organization for Standardization) and IEC (the International Electrotechnica
19、l Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activi
20、ty. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committ
21、ee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to
22、national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held responsib
23、le for identifying any or all such patent rights. ISO/IEC 20117 was prepared by ECMA (as ECMA-347) and was adopted, under a special “fast-track procedure”, by Joint Technical Committee ISO/IEC JTC 1, Information technology, in parallel with its approval by national bodies of ISO and IEC. Copyright I
24、nternational Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 01:28:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 20117:2004(E) vi ISO/IEC 2004 All rights res
25、erved Introduction This International Standard is one of a series defining services and signalling protocols applicable to Private Integrated Services Networks (PISNs). The series uses ISDN concepts as developed by ITU-T and conforms to the framework of International Standards for Open Systems Inter
26、connection as defined by ISO/IEC. This International Standard specifies the signalling protocol for use at the Q reference point in support of the Message Centre Monitoring supplementary service as well as the Mailbox Identification supplementary service. The protocol defined in this International S
27、tandard forms part of the PSS1 protocol (informally known as QSIG). SS-MCM is based on SS-MWI and includes its entire functionality. The interoperability with SS-MWI is therefore guaranteed. Compared to SS-MWI, SS-MCM offers an enhanced functionality for monitoring status changes of messages stored
28、in the Served Users Mailbox as follows: individual activation and deactivation for the monitoring of messages of different Message Type(s) within the Mailbox as well as interrogation of the actual SS-MCM configuration; retrieval of information about all messages (i.e. new and retrieved messages) in
29、the mailbox independent of the Message Status; request of detailed updated information about messages stored in the mailbox. This International Standard is based upon the practical experience of ECMA member companies and the results of their active and continuous participation in the work of ISO/IEC
30、 JTC1, ITU-T, ETSI and other international and national standardization bodies. It represents a pragmatic and widely based consensus. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 0
31、4/04/2007 01:28:23 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO/IEC 20117:2004(E) ISO/IEC 2004 All rights reserved 1 Information technology Telecommunications and information exchange between systems Private Integrated Services Network Inter-ex
32、change signalling protocol Message centre monitoring and mailbox identification supplementary services 1 Scope This International Standard specifies the signalling protocol for the support of the Message Centre Monitoring supplementary service (SS-MCM) as well as the Mailbox Identification supplemen
33、tary service (SS-MID) at the Q reference point between Private Integrated services Network eXchanges (PINXs) connected together within a Private Integrated Services Network (PISN). The supplementary service MCM enables a Served User to get informed by a Message Centre about the status and status cha
34、nges of messages stored in that Served Users Mailbox. The supplementary service MID enables a Message Centre to identify a specific mailbox of a Served User in case the Served User has more than one mailbox within the Message Centre. In addition SS-MID enables a Served User to authenticate himself/h
35、erself at a specific mailbox located within the Messages Centre. The Q reference point is defined in ISO/IEC 11579-1. Service specifications are produced in three stages and according to the method specified in ETS 300 387. This International Standard contains the stage 3 specification for the Q ref
36、erence point and satisfies the requirements identified by the stage 1 and stage 2 specifications in ISO/IEC 20116. The signalling protocol for SS-MCM and SS-MID uses certain aspects of the generic procedures for the control of supplementary services specified in ISO/IEC 11582. This International Sta
37、ndard also specifies additional signalling protocol requirements for the support of interactions at the Q reference point between SS-MCM as well as SS-MID and other supplementary services and ANFs. NOTE Additional interactions that have no impact on the signalling protocol at the Q reference point c
38、an be found in the relevant stage 1 specifications. 2 Conformance In order to conform to this International Standard, a PINX shall satisfy the requirements identified in the Protocol Implementation Conformance Statement (PICS) proforma in Annex A. Conformance to this International Standard includes
39、conforming to those clauses that specify protocol interactions between SS-MCM as well as SS-MID and other supplementary services and ANFs for which signalling protocols at the Q reference point are supported in accordance with the stage 3 standards concerned. Copyright International Organization for
40、 Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 01:28:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 20117:2004(E) 2 ISO/IEC 2004 All rights reserved 3 Normative references T
41、he following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO/IEC 11572:2000, Information technology Telecom
42、munications and information exchange between systems Private Integrated Services Network Circuit mode bearer services Inter-exchange signalling procedures and protocol ISO/IEC 11574:2000, Information technology Telecommunications and information exchange between systems Private Integrated Services N
43、etwork Circuit-mode 64 kbit/s bearer services Service description, functional capabilities and information flows ISO/IEC 11579-1:1994, Information technology Telecommunications and information exchange between systems Private integrated services network Part 1: Reference configuration for PISN Excha
44、nges (PINX) ISO/IEC 11582:2002, Information technology Telecommunications and information exchange between systems Private Integrated Services Network Generic functional protocol for the support of supplementary services Inter-exchange signalling procedures and protocol ISO/IEC 13873:2003, Informati
45、on technology Telecommunications and information exchange between systems Private Integrated Services Network Inter-exchange signalling protocol Call Diversion supplementary services ISO/IEC 15505:2003, Information technology Telecommunications and information exchange between systems Private Integr
46、ated Services Network Specification, functional model and information flows Message Waiting Indication supplementary service ISO/IEC 15506:2003, Information technology Telecommunications and information exchange between systems Private Integrated Services Network Inter-exchange signalling protocol M
47、essage Waiting Indication supplementary service ISO/IEC 20116:2004, Information technology Telecommunications and information exchange between systems Private Integrated Services Network Specification, functional model and information flows Message centre monitoring and mailbox identification supple
48、mentary services ISO 8601:2000, Data elements and interchange formats Information interchange Representation of dates and times ETS 300 387:1994, Private Telecommunication Network (PTN); Method for the specification of basic and supplementary services ITU-T Rec. I.112:1993, Vocabulary of terms for ISDNs ITU-T Rec. I.210:1993, Principles of telecommunication services supported by an ISDN and the means to describe them ITU-T Rec. Q.950:20